Are aluminum risers more durable?

  • 0 Replies
  • 144 Views

Rivernut

  • Join Date: Jan 2017
  • Location: Massachusetts
  • *
  • Newbie
  • *
  • Posts: 18
  • Karma: +0/-0
  • Registered User
    • View Profile
  • Liked:
  • Likes Given: 0
« on: September 16, 2018, 05:40:10 AM »
Iím in the midst of sorting out the water in oil / cracked head issues on my Chevy Vortec 350. It definitely had water getting into a cylinder or two from head cracks and into the crankcase through a leaking intake gasket. I captured most of it in the puke tank.  One of the exhaust manifold bolts was corroded along its length, and an exhaust flapper valve was missing. Trying to sort through the causes, fallout and red-herrings. Iím wondering if a riser or manifold is leaking. The exhaust manifolds and risers are Marinepower aluminum ones. They have never been apart and the boat is 16 years old. It only sees freshwater and is fresh/raw-water cooled. I always drain the manifolds for the winter freeze. The manifolds are still unbolted from the heads. The ports are black with powdery carbon, no gunking up or water washed look to them. Iíve read a lot of the stories of risers going bad and destroying engines, especially in saltwater with iron risers. Very little is written about these high performance aluminum systems. I bought a pair of gaskets just in case I needed them. They were expensive, about $50 with shipping. Iím not sure if I should pull them apart risking damaging the surfaces and replace the paper gaskets. Any of you have experience with aluminum manifold/riser combos?  Do they need frequent replacing like iron ones if only used in rivers and lakes? Here is a pic of the manifolds/risers.

« Last Edit: September 16, 2018, 06:12:50 AM by Rivernut »
  • Boat #1: 2002 Gator / Eagle 2060 bass jet
-- Real boats don't have props!


 


Website Security Test
Powered by EzPortal

Website Security Test