Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - USCvictory

Pages: [1] 2 3 ... 6
1
Boats For Sale / Re: 1976 Tarva/MRED
« on: October 03, 2015, 10:53:31 AM »
I am good with that. Any reason to go to the water I am in. Met a guy through social media that has a 76 19' Mr. ED as well.

2
Boats For Sale / Re: 1976 Tarva/MRED
« on: October 01, 2015, 03:40:30 PM »
Alrighty then....we all need to stay in touch. Not many of us still around. What you think? I'm working on my 18'MrEd as we speak.

That's a bitchin float. I have yet to see a bubble deck style Mr. Ed. What are you putting in it?

3
Boats For Sale / Re: 1976 Tarva/MRED
« on: October 01, 2015, 06:44:51 AM »
I would hang on to the boat too! You looking at a 1 of 13 hulls ever produced by Mr. Ed/Tarva, and as far as I know they only made 4 or 5 jets from that mold. I almost contacted you to come down and buy it so I could start my mini collection.

I hear they only made a limited amount that were MR. Ed before they became Tarva. Didn't know it was that low of a number. I am actually taking it in today to get the bottom Re- Gel Coated. 40 years of nicks, scratches and rash. It's not bad but it'll clean it up. Is that scoop on yours stock?

4
Boats For Sale / Re: 1976 Tarva/MRED
« on: September 23, 2015, 09:33:17 AM »
Well.... someone's getting a really nice,extremely well made cruiser when they buy it. Good luck with your sale.

Thank you. The kind words are appreciated. It is good boat.

5
Boats For Sale / Re: 1976 Tarva/MRED
« on: September 23, 2015, 06:32:06 AM »
Thanks. I did get it from a guy in San Diego. Up in Valley Center. He was the second. I am asking $4,500 for the boat.

6
Boats For Sale / 1976 Tarva/MRED
« on: September 22, 2015, 06:30:28 PM »
NO LONGER FOR SALE. Going to hang on to it and save up to get a second one.

1976 Tarva MRED 19.5'. Titled as an MRED. 460 BBF. All stock. Berkeley JC Pump. Boat is 100% original aside from the carpet and seat bottoms. Everything on the boat works. Dual Battery. I've owned the boat for about 4 months and has been dead reliable. I have taken it to Elsinore 4 consecutive times, Lake Martinez and went to Laughlin and drove it to Needles and back with no issues. I have a Petronix Billet marine Distributor that is new in the box. Boat has a bimini top and a boat cover. boat cover has a 6x6 in tear in left rear corner. Nothing major. Going to more of a low profile jet boat. Tandem Axle trailer. Boat has rash on the bottom. Gel Coat is great for a 40 year old boat. Has a multi lever throttle and forward reverse. Radio (generic but has a Aux jack with sub and 2 6x9"s) No amp. Motor has great oil psi. 60+ on start up and stays at 35+ when cruising after a while. Was told the pump was rebuilt 3 years ago. I can leave the boat in the water for all day with out needing to use a bilge pump. Tires are like new. No trailer brakes. I have 2 27"x 15" teak swim steps that go with the boat. Interior is a 7/10. Looks good cleaned up but has some cracks if you look for the. John 951-691-2684 $4500

7
Random Boat Parts For Sale / Floor mount foot pedal and 12" Cable
« on: September 22, 2015, 06:13:33 PM »
Floor mount foot pedal and 144" (12") Cable. cable is good no issues aside from a couple hot spots. No braid showing $50 in Murrieta 951-691-2684 John


8
Boats For Sale / Re: 1985 Daytona 19 mini Day
« on: September 21, 2012, 09:52:09 AM »
$3300 bump.

Sent from my SPH-D710 using Tapatalk 2

9
Boats For Sale / Re: 1985 Daytona 19 mini Day
« on: September 13, 2012, 12:29:34 PM »
Some more

10
Boats For Sale / Re: 1985 Daytona 19 mini Day
« on: September 13, 2012, 12:28:50 PM »
More pics

11
Boats For Sale / Re: 1985 Daytona 19 mini Day
« on: September 13, 2012, 12:27:57 PM »
Pics

12
Boats For Sale / 1985 Daytona 19 mini Day
« on: September 13, 2012, 12:20:18 PM »
1985 Daytona Tandem Axle trailer with Brand new rims and tires. Registration paid and up to date.(Not Eliminator Daytona) 350 Small block Chevy thats all stock minus Edelbrock carb with Elec choke Berk JE pump. Fires right up every time. Have not had to use the bilge pump all summer. Set up dual batteries with switch. have a 105 Amp Alternator that goes with it. Has matching Bimini Top. Boat also has a cover. The cover is a little old and torn but still covers the boat. All original boat. 2nd owner. Has refinished Teak swim step, radio, amp and 2 6x9's. Not mint condition but still nice. John 951-551-0491 would like to get $4K

13
The No Wake Zone / Re: My Mom....
« on: August 27, 2012, 07:13:25 PM »
Sorry about your loss. Our condolences

Sent from my SPH-D710 using Tapatalk 2

14
SoCal Lakes / Re: Bass Lake?
« on: August 15, 2012, 07:22:56 PM »
Went there as a kid growing up. Grandparents had a cabin there. My wife and I went with our other boat 2 years ago. It had a built BBF and Bassets with baffles and I had to beg the guy to let me slide for being a couple decibels over. We didn't even launch it the second day. Just hung at the cove. They let anybody rent boats so it's a zoo out there on weekends.  They also allow tubes so imaging donuts on a smaller lake and they can happen in front of you at any time. Other then that it is an absolutely beautiful place. I like that area as well as Oakhurst.

15
The No Wake Zone / Re: GPS results
« on: August 12, 2012, 01:06:07 PM »
I think I can top the slow boat category. 20' Daytona stock 350 and Berk JE with me 190 my brother in law 160 2 chairs and ice chest with full tanks 48mph. I know I know almost helmet speeds right.

Sent from my SPH-D710 using Tapatalk 2

16
Projects / Re: Project carrera is finished
« on: August 09, 2012, 09:14:02 AM »
Looks bitchin'.

Sent from my SPH-D710 using Tapatalk 2

17
The No Wake Zone / Re: maybe not my best move???
« on: August 08, 2012, 06:43:07 PM »
Nice truck. Looks clean.

Sent from my SPH-D710 using Tapatalk 2

18
Boats For Sale / Re: Re: Craigslist & ebay boats
« on: August 06, 2012, 05:57:58 AM »
Dirt cheap boat.....

http://phoenix.craigslist.org/wvl/boa/3186394463.html
Lol. That has to be a joke. It looks like you can see where the prop was cutting through dirt.

Sent from my SPH-D710 using Tapatalk 2

19
Lower River / Re: Blythe this weekend
« on: August 05, 2012, 07:23:29 PM »
Yea shouldnt let it bother but it did. Lost my temper for a minute. Felt like i had to apologize to the ole lady for the weekend?

That sucks man. Hopefully all works out for you. I blew a tire on my 97 C3500 and destroyed a wire harness, fender and crumbled the steel fender. I almost felt as if my family wasn't in the car I'd rub a K rail and use my comp on insurance. Where is the oil leak on the F250?

20
It looks like I'm out. Have a huge builders deal on Saturday. Just canceled my room this morning. :'( can't pass on the money opportunity.  So whoever was #2 on the waiting list just went to #1.

Sent from my SPH-D710 using Tapatalk 2

21
The No Wake Zone / Re: Texas bound
« on: August 01, 2012, 08:05:32 PM »
Sorry to hear the bad news. Hope you all have safe trips and returns.

Sent from my SPH-D710 using Tapatalk 2

22
I may be out. FFFFFFFFFFFFFFFFFFUUUUUUUUUUUUUUUCCCCCC CCCCCCCCCCKKKKKKKKKKKKKKKKKKKK!  :banghead: :banghead: :banghead: I have a room set up at the Best western in Parker and 1st on the list at Big River Inn. Waiting to hear back on a new project through work that may hinder me from going.

23
Ya if you had a meter and can do a decibel test that would bee the selling point. They look nice. Great work.

Sent from my SPH-D710 using Tapatalk 2

24
The No Wake Zone / Re: maybe not my best move???
« on: July 30, 2012, 10:29:17 PM »
What type of price range are you looking for?

Sent from my SPH-D710 using Tapatalk 2

25
The No Wake Zone / Re: maybe not my best move???
« on: July 30, 2012, 07:17:15 PM »
My 97 was rode hard and put away wet. Disappointed in the chain if events that haven't only made it worse. I keep full coverage on it and leave the keys in it. Everything on them is expensive to fix.

Sent from my SPH-D710 using Tapatalk 2

Pages: [1] 2 3 ... 6

SMFPacks CMS 1.0.3 © 2021