Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - selbycnlb

Pages: [1]
1
Newer build on a BBC have not been able to open it up because when I hammer down it makes terrible sound. Any ideas?


Sent from my iPhone using SoCal Jet Boats mobile app

2
Boats For Sale / Wtb bubbledeck
« on: June 08, 2017, 12:44:16 PM »
Need full stringer hull minus engine, pump, upholstery


Sent from my iPhone using SoCal Jet Boats mobile app

3
Engines / Engine Parts For Sale / Neovane 105
« on: May 04, 2017, 09:57:22 PM »
Hey everyone I'm looking for either the impeller housing or a complete pump. Is there anyone out there with a spare?


Sent from my iPhone using SoCal Jet Boats mobile app

4
Engines / Engine Parts For Sale / Looking for a good 4.250 bore bbc block
« on: December 17, 2016, 12:16:47 PM »
My oil pickup broke spinning my bearings on a .100 over block. Gonna need a new block. Any one got a gen 4 lying around?


Sent from my iPhone using SoCal Jet Boats

5
Gelcoat / Paint / Fireberglass Repair / Balsa wood flooring
« on: November 09, 2016, 05:49:53 PM »
What is the proper way of installing this stuff? Seams pretty straight forward glass it in. Would like to know resins to use for a clear smooth finish. Brand and type would help out.


Sent from my iPhone using SoCal Jet Boats

6
Hulls / Getting precise stringer match curve without old stringer?
« on: September 14, 2016, 08:43:22 PM »
I could use some help with suggestions with cutting my stringers to match the curve of my hull. Old stringers are shot.I have been using a piece of 3/8 ply cut to 6" to imitate the stringer and just want to get a good match. I measured every foot( front to back) and took measurements of gap then took overall most gap off the front and worked my way back. Seemed to work pretty well just wondering if anyone has a better way? With the vee I was just going to use a 3:12 like framing a roof. I measured a foot side to side and it rose 3 inches so side to side angle I'm pretty sure I'm ok but the front to back I want to be right on before citing into this KD wood


Sent from my iPhone using SoCal Jet Boats

7
Boat Racing / Lifeline racing gear vest rental
« on: July 12, 2016, 01:53:05 PM »
Looking for a couple racing vests for driver and observers for Catalina Race this weekend in Long Beach. I'm located in long beach if you can help, thanks. I'm willing to travel two hours.


Sent from my iPhone using SoCal Jet Boats

8
I have a 455 Olds and need water lines for the straight style Bassett headers. call me if you got some 562-321-1901

Pages: [1]

Website Security Test
Powered by EzPortal
anything
Website Security Test