Where to have logs machined

« **on:** July 24, 2014, 09:53:22 AM »

Hi all,

Where in the IE can i have logs machined? I would like to make sure the gasket surface is flat, also between the log and the snail. The SBC logs i just bought look like they had sealing problems. They have like 3 gaskets between the logs and the snails.

thanks

« **Reply #1 on:** July 24, 2014, 10:20:51 AM »

Try Rettig in Redlands

Sent from my SAMSUNG-SGH-I747 using SoCal Jet Boats mobile app

« **Reply #2 on:** July 24, 2014, 10:43:37 AM »

no dice

called Waynes too.

Have a call out to GS but you know that wont be cheap

« **Reply #3 on:** July 24, 2014, 11:00:52 AM »

Try these guys, they have done all my machine work over the years.

Sent from my iPhone using SoCalJetBoats

« **Reply #4 on:** July 25, 2014, 06:50:05 AM »

I haven't tried logs, but Redlands Muffler does exhaust manifolds all the time. They just run them on a large belt sander.

Might be worth a call to them or your local muffler shop

« **Reply #5 on:** July 25, 2014, 06:54:09 AM »

Most logs will leak at the ports unless you have a good set like Harman. Some have a thick enough block/water running through the port. The small flange type will always have issues.

« **Reply #6 on:** July 25, 2014, 08:21:00 AM »

Quote from: SoCalPSD on July 24, 2014, 11:00:52 AM

Try these guys, they have done all my machine work over the years.

Sent from my iPhone using SoCalJetBoats

I'm with u on that

Sent from my iPhone using SoCal Jet Boats

steves86ta

Where to have logs machined

H20Nut21Bahner

Re: Where to have logs machined

steves86ta

Re: Where to have logs machined

SoCalPSD

Where to have logs machined

crewchief22

Re: Where to have logs machined

Your Mom

Re: Where to have logs machined

hothallett

Re: Where to have logs machined