SoCal Jet Boats

Tech Talk => Engine Mechanical / Electrical => Topic started by: Mattydogg on August 11, 2011, 09:53:31 AM

Title: Battery cable
Post by: Mattydogg on August 11, 2011, 09:53:31 AM
My battery positive cable is getting very hot and sparking dose any one know why???
Title: Re: Battery cable
Post by: mobboss on August 11, 2011, 09:58:48 AM
well one of about 3 reasons. 1, starter is nfg
                                              2, wire to start is bad or going bad
                                              3, you have a ground prob in the boat somewhere???

 start with the starter, it should be the prob, good luck.
Title: Re: Battery cable
Post by: Mattydogg on August 11, 2011, 08:05:11 PM
Changed out the starter and alt. Iam running 4 Gage wire is that to small should I use 2 Gage or bigger  is that why it sparks?
Title: Re: Battery cable
Post by: propless on August 11, 2011, 08:19:22 PM
 Does it spark (slightly) when you first connect it ?  That can be caused by a lot of things.  Memory wire for a stereo, amplifiers, etc, etc.  Most of the time its not an issue, just an initial draw when things are first connected.

 Or is it a BIG spark and the wire gets hot with nothing turned on ?
Title: Re: Battery cable
Post by: Mattydogg on August 12, 2011, 07:46:21 AM
Big spark and do have any thing else connected was so bad melted the battery terminal the first time tried to start it. so now ican connect it and as soon as I turn the ignition to on position it sparks and smokes right away
Title: Re: Battery cable
Post by: fastmarlene on August 12, 2011, 08:05:06 AM
Do not reconnect the positive terminal.  A dead short can result in your battery exploding.  Sounds like you have a dead short in the starter someplace.  Is the solenoid integral with the starter?  Remove the starter as an assembly, using a continuity tester or ohm meter check if the positive connection on the solenoid and starter housing makes a complete circuit.  Remove the solenoid and do the same where the connection is on the starter where power is supplied to the brushes and the starter housing.  What you are doing is determining if the short is in the solenoid itself or the starter.  that will tell you the next parts you need to change or repair.
Title: Re: Battery cable
Post by: Mattydogg on August 12, 2011, 01:01:54 PM
I took the starter out and had it bench tested at auto zone. And the silonid is on starter and it tested good?   Could it be that the battery cables are bad or would the coil be bad is there a way to test the coil to see if there is a short? Thanks
Title: Re: Battery cable
Post by: mobboss on August 12, 2011, 01:37:30 PM
well check to see if your wires were crossed, somethin aint right. it should not have anything to do with your coil. its between your batt and the starter. do you have a fuse block???? try this  pull alll the fuses then put them back in one at a time checking each time .
Title: Re: Battery cable
Post by: Mattydogg on August 12, 2011, 02:52:00 PM
Ok I'll look tonight and check the fuses thank you
Title: Re: Battery cable
Post by: Mattydogg on August 14, 2011, 06:10:39 PM
Ok found out it was the ignition switch and a bad battery cable now it fired right up 2 Gage cables . thanks eveybody for the help. How do I post pictures ???? Thanks
SMFPacks CMS 1.0.3 © 2026