SoCal Jet Boats

Tech Talk => Engine Mechanical / Electrical => Topic started by: GAWnCA on October 29, 2007, 09:33:22 AM

Title: BBF CAM Setup
Post by: GAWnCA on October 29, 2007, 09:33:22 AM: Ok, here's a quick question, at what degree(s) should the CAM be set in a fresh rebuild on a BBF. The rebuild is nothing radical.

Thanks, Greg
Title: Re: BBF CAM Setup
Post by: Ralph Brunt on October 29, 2007, 09:59:09 AM: follow the cam grinders instructions, if you dont have them just put it straight up
Title: Re: BBF CAM Setup
Post by: GAWnCA on October 29, 2007, 10:51:15 AM: Quote from: Ralph Brunt on October 29, 2007, 09:59:09 AM
follow the cam grinders instructions, if you dont have them just put it straight up

Thanks Ralph, I'll ask the guy who is doing the building then and see what he did. Greg
Title: Re: BBF CAM Setup
Post by: Ema Non-Performance Marine - BANNED on October 29, 2007, 01:12:53 PM: Quote from: Ralph Brunt on October 29, 2007, 09:59:09 AM
follow the cam grinders instructions, if you dont have them just put it straight up
If it has an early timing set 0* if it is a '73 and up 4* advanced
if no cam card.
Title: Re: BBF CAM Setup
Post by: GAWnCA on October 29, 2007, 03:21:12 PM: Quote from: Emanon Performance Marine on October 29, 2007, 01:12:53 PM
If it has an early timing set 0* if it is a '73 and up 4* advanced
if no cam card.

It's that engine the blew up and CASCAR is rebuilding. I don't know what CAM he installed but he should know, I hope!!! :)