SoCal Jet Boats
Tech Talk => Engine Mechanical / Electrical => Topic started by: flames on May 14, 2019, 08:08:50 AM
-
I am installing a mini starter on my boat. The stock starter has three wires red to the battery a tan and a yellow. The new starter has a place for 2 one is the battery. How do you wire this up or what wire do you use. I attached pics of old starter
Sent from my iPhone using SoCal Jet Boats mobile app (http://r.tapatalk.com/byo?rid=201)
-
Take a pic of the new starter
Sent from my iPhone using SoCal Jet Boats
-
Jet Boat Engine Harness Diagrams
Here are 4 different engine harness diagrams, complete with wire gauge and colors.
Two of them show points ignition w/1 wire and 3 wire alternators.
The other two show HEI ignition w/1 wire and 3 wire alternators.
If you're using an aftermarket ignition such as an MSD, be sure and follow their instructions for wiring the box to the distributor.
If you're using an MSD R2R distributor by itself:
Black = Ground
Red = Ignition Hot & (+) terminal of coil
Orange = Tach Signal & (-) terminal of coil
No ballast resistor required
https://www.socaljetboats.com/index.php?topic=2326.msg31060#msg31060
Sent from my iPhone using SoCal Jet Boats
-
Here is a picture
-
Here’s mine.
Sent from my iPhone using SoCal Jet Boats mobile app (http://r.tapatalk.com/byo?rid=201)
-
Currently I am not running a solenoid looks like I will have to run one now
Sent from my iPhone using SoCal Jet Boats
-
I’m not an expert. There are alternate ways to wire it depending on what you have. Mine has always had the aux solenoid so it was easiest to keep it. Check out the diagrams a listed previously in that long post and I’m sure you’ll have some experts pipe in soon.
Sent from my iPhone using SoCal Jet Boats