SoCal Jet Boats
Tech Talk => Engine Mechanical / Electrical => Topic started by: Danger731 on June 23, 2010, 12:26:34 PM
-
On my old chevy 350 the mechanical pump had a pushrod that drove the pump, you just had to make sure the tongue was UNDER the rod on installation.
Now I have a Ford 1976 460 CI block. The mechanical pump has a huge tongue. Does ford use fuel pump rods or is the tongue up against the cam lobe ?
-
tongue is on the front of cam on the concentric
-
ok so that should be there... I'll install and fire it up and see what happens... thanks
-
Cam lobe
-
ok so that should be there... I'll install and fire it up and see what happens... thanks
Before you bolt the pump on, look into the pump mounting hole to verify the eccentric is in place.
Cam lobe
Chevy uses a lobe that is part of the cam. Ford and Oldsmobile use an eccentric that bolts on in front of the timing gear.
-
If the pump doesn't sit flush on the mounting pad crank the engine over to get the eccentric on the low side, other wise you could break the fuel pump trying to get it installed.
-
^ thanks for the info
-
Before you bolt the pump on, look into the pump mounting hole to verify the eccentric is in place.
there is something there that looks cleaned off like the tongue has been resting on it....
Chevy uses a lobe that is part of the cam. Ford and Oldsmobile use an eccentric that bolts on in front of the timing gear.
I can't imagine it not being there ????
-
I can't imagine it not being there ????
Sorry, was thinking this might be a fresh pump install as in it used to have an electric. The eccentric just bolts on and people have been known to leave them off if they were planning to not use the mechanical pump.
-
^ gotcha,
The previous owner put the electric on and left the mechanica bolted up, he just plugged the mechanical inlet and outlet. No blocking plate just took it out of the loop. :screwy:
-
Ford makes a heavy duty piece for the pump.
-
meaning ?
-
There is a performance excentric that replaces the stock one. however the other one will work with stock pump the replacement is for heavy duty pumps.