SoCal Jet Boats
Tech Talk => Engine Mechanical / Electrical => Topic started by: eliminator18 on March 10, 2020, 01:14:16 PM
-
Looking for a good electric fuel pump to feed a single dominator 1050. Motor is a 540ci making a little over 700hp n/a. What are you guys running?
Sent from my iPhone using SoCal Jet Boats mobile app (http://r.tapatalk.com/byo?rid=201)
-
I run a holly blue that feeds two 1050's
Sent from my SM-J727T using SoCal Jet Boats mobile app (http://r.tapatalk.com/byo?rid=201)
-
Will this 5/16” fuel line be enough to supply it? Or dose it need to be bigger?
Sent from my iPhone using SoCal Jet Boats mobile app (http://r.tapatalk.com/byo?rid=201)
-
Bigger.
At least 3/8 prolly more like an-10. You want the volume to get it there.
-
ok thanks!
Sent from my iPhone using SoCal Jet Boats
-
Anyone got pictures of where you mounted your fuel pump! Need some ideas where to mount it!
Sent from my iPhone using SoCal Jet Boats
-
I’d definitely go bigger, I’m putting 1/2” pickups in my tanks instead of the 3/8” pickups that are in there. I blew my 600hp motor up because I didn’t have enough volume.
Sent from my iPad using SoCal Jet Boats
-
I’m not a big fan of electric pumps especially on play boats, but it is a hood idea to mount it as low as you can get it. (obviously not on the floor of the boat) Electric pumps are pushers not pullers and last longer when there mounted below the fuel level. I usually mount them on the inside of the stringer behind the engine. I don’t have any pics because like I said I usually use mechanical pumps
Sent from my iPhone using SoCal Jet Boats
-
I do have a pic, this is my uncles boat he just has a carter pump, on it
Sent from my iPhone using SoCal Jet Boats mobile app (http://r.tapatalk.com/byo?rid=201)
-
Looking for a good electric fuel pump to feed a single dominator 1050. Motor is a 540ci making a little over 700hp n/a. What are you guys running?
Sent from my iPhone using SoCal Jet Boats mobile app (http://r.tapatalk.com/byo?rid=201)
I have a Holley blue pump to feed 2 750’s with no issues. I think it would be plenty for a single dominator. I have 1/2” lines from each side tank teed into the pump which is mounted on a piece of aluminum, mounted to the inside of the stringer, behind the motor. From there, it feeds the filter, to the fuel block, to the carbs. All the same size line. Sorry no pic.
Like mentioned, it helps to have it lower. If it’s been a while, I have to “prime” the pump by disconnecting the lines at the tank and fill them with gas.
The Holley can be opened up on the bottom and you can see the pump mechanism. I sometimes open it up to make sure the screen is clear and “lube” it with WD 40 to make sure the moving parts aren’t stuck.
A lot of people like the Aeromotive pumps, but they can be pretty expensive.
Sent from my iPhone using SoCal Jet Boats mobile app (http://r.tapatalk.com/byo?rid=201)
-
Thank for the info guys!

Sent from my iPhone using SoCal Jet Boats