SoCal Jet Boats
Tech Talk => Engine Mechanical / Electrical => Topic started by: Tylerjones on January 13, 2008, 05:05:10 PM
-
Does anyone know of any?
-
Other than myself and a few friends - L&R engine in Santa Fe Springs.
13731 Bora Drive,
Santa fe Springs, CA 90670
(562) 802-0443
-
WHat kind of motor?
-
olds, nothing real special, little head work, cam, the norm. I pretty much just want it gone through. I can also do some trade work.
-
Other than myself and a few friends - L&R engine in Santa Fe Springs.
13731 Bora Drive,
Santa fe Springs, CA 90670
(562) 802-0443
Thanks. Do you want to go through an olds?
-
Thanks. Do you want to go through an olds?
No time... Just take it to L&R
-
Hey Tyler, You may want to try a close friend of mine, Dave at A & D Engines. He has been machining and building engines since 1979. He does awesome work. He is in La Habra @ 1140 S Cypress St #b La Habra 714-879-9671 And tell him that Mark sent ya
-
Also, that reminded me of my other friend Dave - he is into Fords.
D & B Machine
10705 Inez St
Whittier, CA 90605
(562) 946-1473
-
Total Performance
10133 Prospect Ave
Santee, CA 92071
(619) 562-9894
If you're around the San Diego area
-
Thanks everyone.
-
Total Performance
10133 Prospect Ave
Santee, CA 92071
(619) 562-9894
If you're around the San Diego area
These guys are the shit!! They end up on a lot of speed channel shows.
-
Total Performance
10133 Prospect Ave
Santee, CA 92071
(619) 562-9894
If you're around the San Diego area
that would be one of the only place a would go to. ;D
-
p-woman finally has good info >:D
-
Or if you're looking for some serious power there's another shop in east county. But they are more spendy.
Mummert Machine and Development
14368 Olde Highway 80 Suite C
El Cajon, CA 92021
(619) 596-0312
I think they have some olds experience
-
Hey Speedy I thot D & B was outta business about a year or so ago??? Also A & D was featured on the show with motors he built for the cross country race for Boyd Coddington
-
I saw Dave at the hi po meet last month, I just assumed he was still in biz - I haven't talked to him much in the last 3-4 years. I've been using L&R for my machine work, and Flow control for head stuff.
-
I use jim Guthrie, I dont know if he messes with olds though.