SoCal Jet Boats
Tech Talk => Engine Mechanical / Electrical => Topic started by: jetinator on September 06, 2012, 10:08:44 PM
-
Hey guys need some help here can you tell me where to take a 454 engine to.be rebuilt in or around inland empire? Nothing fancy just a stock rebuild I'm helping my brother pull his motor saturday and needs to have it rebuilt.
-
it is not that hard to do your self and you can save alot of money
-
Randy at Jet Boat Plus in Havasu
-
I used Adams Metalizing in Lancaster for my short block and valve job. They did a great job at a reasonable cost. With no traffic it's about 1 1/2 hour drive from you. Check out their website.
-
A &D engines he is here on the boards, his name is dave he does very good work..
there is a thread here somplace (i cant find it) when Brad built his engine at his shop after Dave did all the machine work...
he is the only one i will use after seeing and working with him
hope this helps
ralph
-
if all your going for is stock, you may look into buying a rebuilt motor already done? could be cheaper. and much faster.
-
Wayne's in Riverside if you want to stay local and stock.
-
Love waynes-
A genuine set if mix and matched used pistons, a good set of used straightened reconditioned rods, welded and rewelded cranks, matched heads (ford for fords, gm for gms), all this for a non warranty-able jetboat mota? :screwy:
Id trust a used 100,000 mile BBC out of a dually/suburban first. :thumbup: theres your marine clearances
Or build it yourself, Its not rocket surgery or brain science, just a chebby.
What went wrong on that 454? maybe fix and refresh?
Thats all I got
Daniel
-
Thanks for the responses the motor is getting tired the oil pressure is dropping below 20 once the engine warms up and has excessive crank case pressure.
-
Love waynes-
A genuine set if mix and matched used pistons, a good set of used straightened reconditioned rods, welded and rewelded cranks, matched heads (ford for fords, gm for gms), all this for a non warranty-able jetboat mota? :screwy:
Hey Daniel,
I am not real good at translating drunk posting but what exactly was your problem with Wayne's and when? I have been taking stuff there for over 30 years, from SBC's to a 472 in. Hemi that went in a $100,000 Superbird. 2 months ago I took them 2 different blocks AND they rejected them both because of cracks/repairs that were poorly done by someone else, and very hard to see. They have outlasted every other machine shop in the area they must be doing something right. PM me if you like.
-
Use a straight 50 or 60wt oil......
boat motors will get variable weight oil real hot and cause oil pressure to drop.
At least that's what has happened to me before.
-beerjet-
-
A &D engines he is here on the boards, his name is dave he does very good work..
there is a thread here somplace (i cant find it) when Brad built his engine at his shop after Dave did all the machine work...
he is the only one i will use after seeing and working with him
hope this helps
ralph
Hi Ralph , Hey thanks for your comments. It was great working with you & POPS too ;)