Null


Relaxin Jackson

  • Karma: +0/-0
Motor runs good at mid and low rpm but bad on high rpm
« on: September 20, 2014, 12:59:48 PM »
Ok people this is my first post so hang in there. I had a 455 olds motor rebuilt, the old motor ran ok with the edelbrock 750 marine carb and stock coil/dist but on the new motor it runs good at mid and low rpm but nothing when i mash down on the gas, i cant even mash down right out of the hole, i have to slowly ease in into the throttle.

ANY SUGESTIONS       :screwy:
  • Boat #1: 1974 Plasticraft Libra MIni Day Cruzer
  • Like
    Dislike
    Love
    HaHa
    Angry
    Surprise
    Sad
    Party

mobboss

  • Karma: +15/-0
Re: Motor runs good at mid and low rpm but bad on high rpm
« Reply #1 on: September 20, 2014, 01:08:53 PM »
While the motor was rebuilt , where was the carb??? Was it rebuilt also???


Sent from my iPhone using SoCalJetBoats
  • Boat #1: boat less
  • Like
    Dislike
    Love
    HaHa
    Angry
    Surprise
    Sad
    Party

JBASHAM

  • Karma: +1/-0
Re: Motor runs good at mid and low rpm but bad on high rpm
« Reply #2 on: September 20, 2014, 03:41:36 PM »

Ok people this is my first post so hang in there. I had a 455 olds motor rebuilt, the old motor ran ok with the edelbrock 750 marine carb and stock coil/dist but on the new motor it runs good at mid and low rpm but nothing when i mash down on the gas, i cant even mash down right out of the hole, i have to slowly ease in into the throttle.

ANY SUGESTIONS       :screwy:

Check to see if your accelerator pump is working and verify you are actually getting wide open throttle( with the engine off)


Sent from my iPhone using SoCalJetBoats
  • Boat #1: 1988 19ft Sunray I/O
  • Boat #2: 1982 18ft Bahner Bubbledeck
  • Like
    Dislike
    Love
    HaHa
    Angry
    Surprise
    Sad
    Party

crewchief22

  • Karma: +66/-0
Re: Motor runs good at mid and low rpm but bad on high rpm
« Reply #3 on: September 20, 2014, 10:53:31 PM »
... the new motor it runs good at mid and low rpm but nothing when i mash down on the gas, i cant even mash down right out of the hole, i have to slowly ease in into the throttle.

Going to need a little more information even to make a good guess.

What is it doing when you get near full throttle?  Does it just stop pulling rpm, does it backfire or sputter?

What does it do when you try a hard acceleration from stop?

At what rpm does it start to act up?

 
  • Boat #1: '77 Hondo Pantera GT Jet
  • Like
    Dislike
    Love
    HaHa
    Angry
    Surprise
    Sad
    Party
"Racing is life!  Anything that happens before or after, is just waiting"    Steve McQueen

The problem with America is stupidity. I'm not saying there should be a capital punishment for stupidity, but why don't we just take the safety labels off of everything and let the problem solve itself?

socaljst1970

  • Karma: +8/-0
Re: Motor runs good at mid and low rpm but bad on high rpm
« Reply #4 on: September 21, 2014, 02:12:47 PM »
Over the years have had a number of OLDS and on one of them I had a similar issue.  Turned out to be voltage - too weak - new battery and cleaned up the ground on the block - got my spark back to 100%
  • Boat #1: 2001 Tom Papp Racing Mirage Fundeck
  • Like
    Dislike
    Love
    HaHa
    Angry
    Surprise
    Sad
    Party
Jason & Victoria
2001 Tom Papp Racing Mirage Deck Boat

 


Null

SMFPacks CMS 1.0.3 © 2026