i need to change the oil in the boat and change my drive line, at about 3200-3600 it would growl then go away. i am not sure if  it's the shaft or the angle i set the motor i put a shaft in that didn't need a pto because i wanted all the interior room i could get.
 we got the motor out

then set about to remove the shaft

then this note to self dont use locktite on bolts. pops always told me not to use it here

i stared to chisel it out but that was getting me now where these are grade 8 bolts so drilling them is next to impossible. i dont have a torch to melt the lock tite so i stick the drill in there and build up  some heat, and walla

the end result


you can see the new shaft with pto in this pic

oh yeah, got the oil changed too

Check out pops hard at work,does he even let you help