Well as it says I'm a new one, this is what I have....76' Eliminator bubble deck, delta V bottom I think,
BBF 460 with offy single carb tunnel, D3ve a2a heads, 600 cfm Holley, Berkeley 12jc pump/jet, stock rock grate.

So here is my ?....currently full pedal mash nets me 62mph on GPS at 5300 rpm, trimmed up with a slight chop, full rooster and 15 gallons gas, oh and 300 lbs of humans , 2 of us. 
For you experts out there, is there anything odd about those numbers or anything I could change up right away on the motor to make it a bit stronger running.

Oh and I did a compression check and it's sittin right around 8:1

I'm suprised you're getting the rpm you are with only a 600 on a tunnel ram (something sounds odd to me).

Depending on how much you want to invest I'd recommend getting a dual carb top for the tunnel and adding another 600 or get a Team G, Victor Jr type manifold and go to an 800-850 carb.

just cause you have milky oil does not always mean you have a blown head gasket. that is a boat in water. just my 2 cents.

Oh and I'm still working on how to post pics.  I bought it from jet crazy here on the forum, and I just checked and the original pics and add he posted are still up. 

I also had similar milkshake caused by bad intake gasket leaking water in to lifter valley.