SoCal Jet Boats

Tech Talk => Engine Mechanical / Electrical => Topic started by: Lanhamnk on October 23, 2008, 10:29:23 PM

Title: New wiring harness help
Post by: Lanhamnk on October 23, 2008, 10:29:23 PM

Hay guys I need help bad. I need to know in depth how to rewire my boat. From lights to motor. So here is whet i have to hook up bilge pump front and rear lights, ignition, volt, hour, tachometer, oil, temp, fuel, and fuel. What size wire should I use also what colors and what colors go to what. Were do they all go lol.. I need pics and lots of help . Should I put a fuse in? Can I run all the power and grounds from the ignition? It's a ford 460 with 3 wire alt and points distributor with coil and ballast resistor. It has a wire block on the bell housing.  Thanks guys  ALL THE HELP I CAN GET!!!!! :banghead: :banghead: :banghead: :banghead: :banghead: :banghead: :banghead: :banghead: :banghead:

Title: Re: New wiring harness help
Post by: nathan72 on October 23, 2008, 10:43:18 PM

http://www.hotboat.com/forums/attachment.php?attachmentid=45605&d-1210481094

Title: Re: New wiring harness help
Post by: crewchief22 on October 23, 2008, 10:45:20 PM

http://www.socaljetboats.com/index.php?topic=4319.msg61551#msg61551

Title: Re: New wiring harness help
Post by: nathan72 on October 23, 2008, 10:46:18 PM

i hope that helps!

Title: Re: New wiring harness help
Post by: crewchief22 on October 23, 2008, 10:53:28 PM

Here is another link

http://www.socaljetboats.com/index.php?topic=2326.msg31060#msg31060

Good luck  ;D