SoCal Jet Boats

Tech Talk => Engine Mechanical / Electrical => Topic started by: dirtbag1 on August 28, 2010, 03:23:48 PM

Title: oil cooler
Post by: dirtbag1 on August 28, 2010, 03:23:48 PM
Looken for some info on running an oil cooler. Just built my engine and dyno guy says it would be a good idea to run one. Not sure on witch way to plum it in. I know how to run it threw the water coming in from the pump then to the engine, also heard of after, Then I heard of running it separate, or on its own threw a pick-up out the back of the boat. Pros/cons anything will help Thanks.
Title: Re: oil cooler
Post by: GT Jets on August 28, 2010, 03:51:21 PM
How do you run the boat? Do you normally run short sprints, or do you run hard for long length of time?

I ran the race boat oil cooler on a line leaving the heat exchanger (closed cooling deal), the reason I did that was I wanted to oil to be able to be heated quicker too, the cooler was somewhat over sized and we sometime saw water temps in the river in the low 50's..

It is my humble opinion that you should run it on the outlet of the engine, the oil has to get over 220*F to really burn off any moisture, but you don't want to exceed 250*F or so, typical water temperature leaving a Big Block Chevy on a jet is about 140*-150* tops, so cooling the oil is easy with that kind of water temps... 8)

I am sure there are more opinions out there, so don't take mine as gospel, it's just the way I do things  :thumbup:

You could always run a three way valve and throttle between warm/cold, just more plumbing and more headaches...

With my 468 Chevy, I run the water from the t-stat housing to the oil cooler then to the dump line. Oil temps run in the 190*F to 240* all day long, never had any issues.  I am not using the Dan Olson cooler BTW, I use a custom tube in tube cooler I built special for this boat.

GT
Title: Re: oil cooler
Post by: dirtbag1 on August 29, 2010, 05:58:51 PM
Thanks for the info, If anything I run the boat for longer length of time, on lake havasu. running it from the t-stat to cooler then dump makes cents- like you say. Thanks again for the input.
Title: Re: oil cooler
Post by: ROMPERSTOMPER on August 30, 2010, 05:51:59 PM
Shit I'm running my oil cooler from the seastrainer, and no temp gauge. :banghead: I better get on that b4 running again. Can only have my foot in it for 30-45 min b4 I run out of fuel, dang old bbc, sucks down more juice than my gf at a open bar. What do you consider a long period of time? And 250% is prime for iol temp ? on a racy bbc vroom vroom?
Title: Re: oil cooler
Post by: GT Jets on August 30, 2010, 08:10:36 PM
Shit I'm running my oil cooler from the seastrainer, and no temp gauge. :banghead: I better get on that b4 running again. Can only have my foot in it for 30-45 min b4 I run out of fuel, dang old bbc, sucks down more juice than my gf at a open bar. What do you consider a long period of time? And 250% is prime for iol temp ? on a racy bbc vroom vroom?


Long period of time for me was 38 river miles.... :screwy:  As far as this topic is concerned I would say 15 minutes or so.

As far as the 250*, just under that gives me the warm and fuzzies, I don't know about anyone else  :-\

GT
SMFPacks CMS 1.0.3 © 2026