SoCal Jet Boats
Tech Talk => Engine Mechanical / Electrical => Topic started by: Beaveretriever on July 22, 2008, 11:08:03 PM
-
im looking into getting a 10 quart 454 oil pan. will i need a longer pickup tube to reach down to the oil in the deeper pan? i feel like a retard asking some of these questions but im not a V8 guy really i can get around them. so just bear with me. also is there any different oil pan gasket that i would need to get? pan bolts those kind of things. if any one has any pictures of any motor with after market oil pans and all the goodies that need to be added. thanks for alot of all your help SCJB
The Beav
-
im looking into getting a 10 quart 454 oil pan. will i need a longer pickup tube to reach down to the oil in the deeper pan? i feel like a retard asking some of these questions but im not a V8 guy really i can get around them. so just bear with me. also is there any different oil pan gasket that i would need to get? pan bolts those kind of things. if any one has any pictures of any motor with after market oil pans and all the goodies that need to be added. thanks for alot of all your help SCJB
The Beav
Hey Beav, the pick-up on my Dooley is just a factory POS, because my pan uses a factory "blank" and is added on to. The pick-up needs to mach the pan and sometimes still need to be "tweaked" to fit right (too close to the bottom, or too far away) I think most of the time the pan manufacturer will tell you what pick-up works best.
As far as gaskets and crap, I used four 5/16" studs on the corners and factory style bolts with star washers for the rest of the 1/4" bolt holes, and FelPro OEM style gaskets work fine for me, I have seen some people use the silicone one-piece gasket but don't know if they are worth the money.
A good quality windage tray is recomended, mine is just a Moroso kit that I got from a swapmeet for $15, but test fit them first to make sure the friggen dipstick goes through the hole in the tray, mine was about an inch off so I used an electrical knock out punch to do the "adjustment".
I have three different pans sitting in my shop, if you need I can take a couple of pics to show how different they are, its pretty suprising. My old boat had a Milodon "jetboat" pan and was pretty nice, but this boat got the "Swapmeet" treatment early on, so nothing is really "virgin" if you know what I mean.... ::)
-
Beaver,
I have a Moroso Jet Boat Pan. You should get the pickup they recommend that comes with it. Also with simple math and a square you can get the depth. The pick up should be about 3/8" away from the bottom of the pan. I measured my moroso one as well it was dead on.
T.J.
-
ya i just ordered a jet boat pan as well. and it came with the pickup and installation was dead on..
a little pricey but def worth it.
-
I checked the pickup depth with a small peice of clay. Don't forget to mark the dipstick after you get it on and fill it with the correct number of quarts.
-
Make shure you specify jet or v drive because the pick up is completly different because then motor sits backwards. I learnd the hard way buying a used one. Guy said it was for a jet and it wasnt. took me a while to figure out why I had no oil pressure.