Null


motocam360

  • Karma: +0/-0
Water Routing for Center Riser Exhaust
« on: September 06, 2020, 01:36:50 am »
I finally found some exhaust manifolds that match up with the transom holes for repowering this boat from a 455 to a 460.

However, the riser water line requirements seem to be different than the standard logs with jugs.  I want to have the Berkley feed water into the manifold so it gets pre-heated before entering the engine, but there is no return line port like the typical jugs have.  Can somebody tell me how to route the cooling water so it can be pre-heated first?





  • Boat #1: 1976 Caldwell 19' Berkley jet
  • Like
    Dislike
    Love
    HaHa
    Angry
    Surprise
    Sad
    Party

 


Null

SMFPacks CMS 1.0.3 © 2023