BBC machined 2 bolt block

« **on:** March 30, 2009, 11:53:50 AM »

I have a 2 bolt 454 block, hot tanked and freshly bored and honed to .040" over $375

« **Reply #1 on:** March 30, 2009, 01:34:33 PM »

Pictures.....

« **Reply #2 on:** March 31, 2009, 01:38:03 PM »

Are the cam bearings installed?

« **Reply #3 on:** March 31, 2009, 02:18:07 PM »

Quote from: 75rogers on March 31, 2009, 01:38:03 PM

Are the cam bearings installed?

Good question, I had to go look. The cam bearings in it are used. I will install a new set for just the cost of the bearings if you want. I normally grind and wash a block prior to installing cam bearings.

« **Reply #4 on:** March 31, 2009, 02:59:43 PM »

I just pulled a 455 out of my jet boat and am trying to decide if I want to build a bbc from scratch or find a complete motor. Not looking for big HP, just something to get on the water.

obnoxious001

BBC machined 2 bolt block

snuff630

Re: BBC machined 2 bolt block

75rogers

Re: BBC machined 2 bolt block

obnoxious001

Re: BBC machined 2 bolt block

75rogers

Re: BBC machined 2 bolt block