SoCal Jet Boats

Classifieds => Engines / Engine Parts For Sale => Topic started by: BOOST on November 08, 2009, 04:21:02 PM

Title: Holley 660
Post by: BOOST on November 08, 2009, 04:21:02 PM

      Just got done going through the carbs Holley 660 center squirters mechanical secondary 50cc accelerator pumps new 750 base plates polished front and rear metering blocks milled off air horns new throttle bracket, linkage Aero Motive regulator,fuel pressure gauge and hard lines $600.00 obo

Title: Re: Holley 660
Post by: BOOST on November 13, 2009, 04:30:51 PM

  ttt

Title: Re: Holley 660
Post by: Marcsrollin on November 13, 2009, 06:28:52 PM

Sweet Deal!! What are you going to run after these sell?

Title: Re: Holley 660
Post by: BOOST on November 13, 2009, 07:17:52 PM

Quote from: Marcsrollin on November 13, 2009, 06:28:52 PM

Sweet Deal!! What are you going to run after these sell?

You been lagging bro two 750 Quickfuel

Title: Re: Holley 660
Post by: Ralph Brunt on November 14, 2009, 06:01:41 AM

Quote from: boost on November 13, 2009, 07:17:52 PM

You been lagging bro two 750 Quickfuel

gunna be one hell of a family boat >:D :thumbup:

Title: Re: Holley 660
Post by: Brad @ SCJB on November 14, 2009, 06:22:48 AM

those QFT's sure are purdy....arent they?

(https://www.socaljetboats.com/proxy.php?request=http%3A%2F%2Fwww.performanceboats.com%2Fhtml%2Fforums%2Fattachment.php%3Fattachmentid%3D59561%26amp%3Bstc%3D1%26amp%3Bd%3D1258205192&hash=5ccd36bd4669677cdcdfb1d70b13c766dedf7ca7)

Title: Re: Holley 660
Post by: BOOST on November 15, 2009, 01:27:00 PM

  These carbs will cost $1100 for the pair new with no mods done to them. I had the metering blocks reworked to give more air to the fuel being pulled out the boosters. Main body been blened to increase air flow.I"m only asking $600.00 

    I also have new set of float bowls to make them dual inlet instead of of single how trick would that be to have a 660 four corner idle center squirter. :thumbup:

Title: Re: Holley 660
Post by: BOOST on November 15, 2009, 01:45:48 PM

Quote from: Brad @ SoCalJetBoats.com on November 14, 2009, 06:22:48 AM

those QFT's sure are purdy....arent they?

(https://www.socaljetboats.com/proxy.php?request=http%3A%2F%2Fwww.performanceboats.com%2Fhtml%2Fforums%2Fattachment.php%3Fattachmentid%3D59561%26amp%3Bstc%3D1%26amp%3Bd%3D1258205192&hash=5ccd36bd4669677cdcdfb1d70b13c766dedf7ca7)

Sh't your carb makes mine look small ;)

Title: Re: Holley 660
Post by: bbfsouthwind on November 17, 2009, 09:22:17 PM

Why did you switch to two 750's for? And what did you paint the carbs with?

Title: Re: Holley 660
Post by: BOOST on November 17, 2009, 09:40:12 PM

Quote from: bbfsouthwind on November 17, 2009, 09:22:17 PM

Why did you switch to two 750's for? And what did you paint the carbs with?

  Went with the 750's just because i got a good deal on them :screwy: put my self in a hole cause i just finished getting the 660 dialed in. painted them with epoxy paint out of a rattle can, if they don't sell going to get them powder coated and put the dual inlet bowls on them.

Title: Re: Holley 660
Post by: Just Electric on November 17, 2009, 09:50:55 PM

if my deal fails i might have to try and pic these up.i will let you know next tuesday if there still around

Title: Re: Holley 660
Post by: BOOST on November 17, 2009, 09:58:51 PM

Quote from: Just Electric on November 17, 2009, 09:50:55 PM

if my deal fails i might have to try and pic these up.i will let you know next tuesday if there still around

  :thumbup:

Title: Re: Holley 660
Post by: Just Electric on November 17, 2009, 11:26:55 PM

i will let you know for sure thanks bri