SoCal Jet Boats
Tech Talk => Gelcoat / Paint / Fireberglass Repair => Topic started by: lupo1904 on November 21, 2010, 02:39:35 PM
-
has anybody used 1300 to 2000 degree paint on there headers? do u think it would flake off ?
-
I used BBQ silver (grey) on mine, they looked OK till a day on the river, then they were dull and started to rust, did it 3 or 4 times that season. Black might not show the rust as bad. I went stainless after that :thumbup:
Daniel
Mash on it
-
thanks i might just have to try the black bbq paint.do u no of anything that will help get the old carpet glue of the inside of my hull,so i can lay some new carpet down.
-
I have been fighting carpet glue for many hours now, finally I found 2 tools that will remove it. One is a paint/ rust stripper wheel for a grinder, other is one of those oscillating tools with a scrape blade for the heavy stuff.
-
Lacquer Thinner works great for carpet glue let it sit a few minutes and it scrapes right off.
-
Vht makes a header paint that is ceramic...you half to cure it...that would probably be your best bet
-
okidoki ill try the laquer thinner and ill look for the vht ceramic paint :thumbup: :thumbup: i just dont wanna waste the money on jet coating them black cause there kinda soft by the water nipples
-
looooopster, swap headers and spend the money on these ones. foooo
-
na no worries u needed them more then me
-
yea whatever dude
-
u no wut u got the same attitude as my buddies 14 year old daughter, this aint myspace
-
ohhhh you pulled out the myspace joke huh? ;D you shoulda used that 1 a while ago gina. good laugh though.
-
thought you would like that sucka
-
serious about the headers :screwy:, don't act all stuck up bro.
-
wuts with u and calling me stuck up,you just do it cause u no it bugs me. i gave u those headers cause your were shot so just let it be