As far as resin would this stuff work for stringers or is there somewhere I should go in particular to get the resin


Sent from my iPhone using SoCal Jet Boats

Ok so there is a boat repair shop in Yucaipa called ron's marine is anyone familiar with them and know if they have the stuff that is needed for stringers


Sent from my iPad using SoCal Jet Boats

check out some online distributors.  theres one in san diego....aeromarine.   also, uscomposites.....tap plastics...
theres a few.

stringers can be done alone....but help makes it easier.  gotta move quick alone or resin gels in cup.  remember, they all will produce heat.  epoxy can get hot enough to melt the cup its in....or at least too hot to hold.  spreading it out like in a plastic dish...plate....paint tray with help radiate the heat and minimize premature gelling. do a search on here if you havent already....one stringer at a time....or put boat on stands....if not, at least off of bunks.  good luck man.

I would go to sher fab in Ontario for fiberglass  supplys .  They will have everything  you  need.  And they have  pretty  good  prices. Get your lumber at ganahl in corona . And lots of throw away paint brushes and nitrile gloves. I used  about 4 gallons of resin . a lot was wasted because  i tried to work  on  it  when it was too hot outside. Looks like im headed  in that direction again if i dont stop procrastinating .