SoCal Jet Boats
Tech Talk => Jet Pumps => Topic started by: connorstexas on May 18, 2016, 09:47:25 AM
-
aluminum? do impellers have any way of identifying what cut it is?
Sent from my iPhone using SoCal Jet Boats
-
Not from that side...
It will either be stamped (which should be verified by measuring) or you can measure it and compare it to a cut chart.
Looks aluminum, but a bit bright. Could be either.
GT
-
aluminum?
Sent from my iPhone using SoCal Jet Boats
By looking at that pic, and comparing the stainless shaft (color) to the impeller, it looks like aluminum.
do impellers have any way of identifying what cut it is?
Sent from my iPhone using SoCal Jet Boats
Yes, but not from that side. An impeller size is determined by the 'small diameter' on the exit side. Often Impellers are marked wrong, as they start out as an 'A', and are turned down to a smaller cut, 'A/B', 'B', 'B/C', etc...but still marked as an 'A'.
Pull the bowl and find out.
Dan'l
-
cool thanks guys. I'll pull it tonight and post a picture of what I find
Sent from my iPhone using SoCal Jet Boats