SoCal Jet Boats
Tech Talk => Jet Pumps => Topic started by: jonnycr500 on July 28, 2017, 10:36:40 AM
-
Hello. I can't remove the two oil fill plugs on my Berk JG pump.
It's a '79 and bought boat used. Any helpful info on how to remove them?
The square head twists a bit but not the entire plug. I'm afraid if I use too much
muscle it will just break off.
Thanks.
-
I'm having the same problem with one of mine. I clamped down on it with vice grips and it didn't budge. Just shredded it. Thinking if drilling it out
Sent from my iPhone using SoCal Jet Boats
-
MAPP gas torch around the plug.
Sent from my SM-G930T using SoCal Jet Boats mobile app (http://r.tapatalk.com/byo?rid=201)
-
I put some pb blast, clesned it heat it up for a couple minutes with torch used some vice grips came right off then replaced
Sent from my SM-G930T using SoCal Jet Boats mobile app (http://r.tapatalk.com/byo?rid=201)
-
Hit it with a torch then quench it with penetrant. Let it cool completely, come back and heat it again and twist them out.
Happens all the time. Use PTFE paste on the new ones... ;)
GT
-
Hit it with a torch then quench it with penetrant. Let it cool completely, come back and heat it again and twist them out.
Happens all the time. Use PTFE paste on the new ones... ;)
GT
That's what I meant...
Sent from my SM-G930T using SoCal Jet Boats mobile app (http://r.tapatalk.com/byo?rid=201)
-
That's what I meant...
Sent from my SM-G930T using SoCal Jet Boats mobile app (http://r.tapatalk.com/byo?rid=201)
Oh I know...... Just helping you there brother man... 8)
GT
-
Thanks everybody for the info. I'll give it a try. August 18-19 I'll be at Needles-Pirates. Have a cold one on me!