SoCal Jet Boats
Tech Talk => Jet Pumps => Topic started by: mopartec on July 19, 2009, 06:16:25 PM
-
im just purchased a 1974 jrs fiberglass jet boat. it has a 12je pump. the pump was removed and laying in the hull. im am going to reinstall it. it looks like it was expoxyed to the hull then bolted on to the hull.does this need to be re epoxyed or can be installed with marine grade silicone as with all other jet boat transome plates. thanks.
-
I would have to beleive they were all epoxied in there for a very valid reason (Could be an intregral part of the hull integrity? hellifIknow why, just guessing).
Therefore I would epoxy it back in and not worry about the whys. I Have no idea what epoxy was used or should be. PM JBP, Tom's apparently done this a time or two.
Ray
-
Insert or "transome mount Jets (12je, Dom 12 TD etc) are desingned to be installed with and bedded with epoxy for strength and proper sealing , its usually takes a "kit" whoich is around 30 bucks , call if we can help Tom
-
I removed the je from my carlson cvx 20 , it was not epoxied or ever had been. It had a rubber feeling caulk between the hull and suction housing and it was a pain in the ass to remove. The je I bought from a guy here on scjb forum was epoxied (shit ,it still had part of the boat on it when it got here ,removed with a skill saw I think and took 4hrs to clean off with assorted air tools).I'm thinking buying a boat with a epoxied je removed from it would be buying a boat with alot of hull damage to repair.Check your boat and see if the je that came with your boat,came out of your boat. If your hull looks like the pump was removed with a chopping axe,it was epoxied, if it will clean up with some elbow grease and a putty knife it was bolted and caulked. I'm going to use PAR clear sealent to install my je.It will dry clear and will stick to air tho its also hell to remove but tough as hell. My thinking on this is ,put it back the way it came out.