Null


simidan

  • Karma: +0/-0
Place diverter double seal install?
« on: September 01, 2011, 05:55:42 pm »
So I noticed a piece of plastic sticking out of my diverter knuckle. Thinking it was just a piece of trash I started yanking on it. Damn thing would not come out. Then I take the diverter apart to find where an o-ring should be, but instead I have a torn up straw. Come to find out there is an o-ring for that and promptly called JBP. It was here the next fricking day! :thumbup: Thanks Josh.

So does it matter where the split goes? Top, bottom?
Thanks again.
« Last Edit: September 01, 2011, 06:20:48 pm by simidan »
  • Boat #1: Someone elses
  • Like
    Dislike
    Love
    HaHa
    Angry
    Surprise
    Sad
    Party

Oldsquirt

  • Karma: +1/-0
Re: Place diverter double seal install?
« Reply #1 on: September 01, 2011, 07:12:01 pm »
On the side, adjacent to one of the pivot pin holes. Less movement in that area, so less likelyhood of pulling it apart.
  • Like
    Dislike
    Love
    HaHa
    Angry
    Surprise
    Sad
    Party

simidan

  • Karma: +0/-0
Re: Place diverter double seal install?
« Reply #2 on: September 01, 2011, 07:17:14 pm »
Makes sense. Thank you sir.
  • Boat #1: Someone elses
  • Like
    Dislike
    Love
    HaHa
    Angry
    Surprise
    Sad
    Party

jim brock

  • Karma: +17/-0
Re: Place diverter double seal install?
« Reply #3 on: September 01, 2011, 11:15:17 pm »
if you would have came to my shop you could of had it the same day!!!!!!
  • Like
    Dislike
    Love
    HaHa
    Angry
    Surprise
    Sad
    Party

simidan

  • Karma: +0/-0
Re: Place diverter double seal install?
« Reply #4 on: September 02, 2011, 04:58:49 am »
Doh! Sometimes I just dont think.
  • Boat #1: Someone elses
  • Like
    Dislike
    Love
    HaHa
    Angry
    Surprise
    Sad
    Party

 


Null

SMFPacks CMS 1.0.3 © 2023