909 376 6573 when you are ready

I dont know if you know this...but to powder coat it must conduct electricity. At least you paid him up-front.

its still here so come on by and take a look. thanks for reminding me about the dipstick. i need to start making lists

you have to look at it with inner stoner

Thanks, I here that a lot.

OK here we go, the gel and paint are orginal and are fair, the boat has a satin look to it and im not sure why, some say its the clear is worn off. There are some stress cracks from going over the side, i here they are common with this hull type. It was also used by howard and wicthcraft, so i here. The white in the photo's is gel and buffs out nicely. A new deck was installed by the old guy i got it from. He used 3/4" ply and coated it all with fiberglass and put down new carpet at the time. The interior is clean and could use a scrubbing only one small hole that looks like its from a cigarrette. Transom is in good condition with the exhaust going through it. I put some lumber around the tie downs and exhaust. Aluminum fuel tanks on each gunnel that hold about 8 gals. each. Bilge is clean and i think its because of the recent rebuild. The engine runs cold , even at idle. This is old school and has no bimini or stereo, but it does have new gauges (tach not connected) new steering, throttle, direction cable with a beer tap shifter (miller lite). I took off the key ignition and installed a push button and toggles to start it. I got home late so when the suns up Ill take some better photo's and email them to you, and any one else who would like them.

i figuered it out

Done

Did you get'em?