Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - highlandchas

Pages: [1]

Engine Mechanical / Electrical / Re: 502 engine

« on: July 31, 2016, 12:51:40 PM »

Yes thank you for the info plan on doing that nothing like knowing your future......

I am also gonna put me a drain on my oil pan with a hose to make changing my oil way less of a choir.....

Engine Mechanical / Electrical / Re: 502 engine

« on: July 31, 2016, 11:19:06 AM »

Actually change of plans pulling my motor going to change the oil oil filter and check the pan for the missing push rod...

Engine Mechanical / Electrical / Re: 502 engine

« on: July 30, 2016, 04:08:15 PM »

Sounds pretty good now greasing up the Dominator gonna go take it it to the lake I will take some pics of the Jet a vator throwing up some 200 ft roost.....

Engine Mechanical / Electrical / Re: 502 engine

« on: July 30, 2016, 03:50:44 PM »

No never found it must be down in the 12 quart oil pan not on top of the motor anywhere....

Engine Mechanical / Electrical / Re: 502 engine

« on: July 30, 2016, 03:45:50 PM »

Got all the valves adjusted all back together getting my 800 double pumper rebuilt then its the river time.....

Engine Mechanical / Electrical / Re: 502 engine

« on: July 29, 2016, 06:51:50 AM »

Yes they are ....very nice set up...

Engine Mechanical / Electrical / Re: 502 engine

« on: July 28, 2016, 07:05:27 PM »

Yes I did that's why i am going through it making sure everything is working as it should!

Engine Mechanical / Electrical / Re: 502 engine

« on: July 28, 2016, 06:14:54 PM »

Yes I have a few pictures of my boat it;s a ultra boat with a Dominator jet with a 502 big block with a hydraulic jet a vator....

Engine Mechanical / Electrical / Re: 502 engine

« on: July 28, 2016, 06:02:30 PM »

Well thank you all for the replies it was the push rod on the intake are shorter that the push rods on the exhaust going to get the new one at 7 am and go from there thank you all once again....

Engine Mechanical / Electrical / 502 engine

« on: July 28, 2016, 04:31:45 PM »

What would make a push rod bend when turning the motor over? I bought a 21 foot ultra with Brodix heads on a 502 and when i took off the valve cover I noticed that I was missing a push rod i went to the auto parts store and picked up another push rod it was a melling push rod 308 and it would not let me start the rocker arm to the threads it was like it was too long. I grabbed another push rod shorter put it in tighten it down as soon as i turned it over i seen the push rod was bend what would cause that please any help???The engine has big brodie heads and is a roller motor with crane cams roller rocker arms...well figured it out the intake pushrods are shorter than the exhaust push rods ......

Pages: [1]