I'm looking for:
Boss 9 heads
Boss 429 headers Twistie or straight
Boss 429 blower manifold
Blower idler bracket
Crank hub (1 PC)
drive shaft
motor mounts (Rail)
10 qt oil pan


Will sell or trade the following:

I have complete Kenne Bell Shelby GT500 Twin Screw super Charger kit $4900.00

9" rear axle assembly with 35 spline internals and ARB air locker $2350.00

Kook custom headers ( coated) $850.00

Shelby GT500 parts--Kooks headers, complete KB 2.8 twin screw setup, 9" rear end

Kooks custom headers (jet hot coated) with cats and H pipe. $850.00 for complete Kooks setup.

Also complete setup, KB 2.8 twin screw/ mammoth intake. sell for 4500.00 schmokin deal! Bolt in and go.
Have 725hp pump gas setup and 805rwhp pulley.
My car dynoed 670rwhp with the 91 octane tune and Kooks headers. The small pulley should be around 855rwhp with the smaller pulley.

Currie 9" housing with all Strange 35 spline components, ARB air locker, anti lock rings, aluminum driveshaft: only 900 miles on rear end assembly and it has not been to the drag races yet. ARB compressor still in box....install and go! $2200.00

Parts are getting removed this week.

I live in San Diego and am looking for a set of good cast iron BBC rectangle port/open chamber heads. I don't want to spend 2k on aluminum heads.


Thanks, Gordon