Null

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - kachina 22

Pages: [1]
1
The No Wake Zone / Trailer reg
« on: July 01, 2015, 07:25:33 PM »
Can anybody heeeeelp???

Trying to renew my trailer reg and cant find the location on the CA DMV site, can anybody help me with this??????

Thanks

2
Engine Mechanical / Electrical / fly wheel
« on: February 14, 2015, 05:40:07 AM »
Is a 168 tooth fly wheel standard for a 454? 

3
Engine Mechanical / Electrical / cant get new motor to start
« on: April 13, 2014, 08:10:21 AM »
Just built a new motor for the boat and can't get the dam thing to start!  Purchased a L's 6 short block re-done and ready to go, bolted all my old stuff on.  My starter was shot and is rear top right hand mount, always been reverse rotation!  Starter turns ccw rotating motor cw, my did rotor is turning ccw.  Motor pops back fires and using standard wire arrangement,  12756348. What amiI doing wrong or is rotation wrong some place?? Heeeelp

Thanks

4
Engine Mechanical / Electrical / flat top piston with bevel at top
« on: March 01, 2014, 07:28:36 PM »
Hey guy, doing  a new build and using flat top pistons with bevel, what gasket should I use to get most compression?
Thx

5
Engine Mechanical / Electrical / flat top piston with bevel at top
« on: March 01, 2014, 07:27:53 PM »
Hey guy, doing  a new build and using flat top pistons with bevel, what gasket should I use to get most compression?
Thx

6
Jet Pumps / Couple tech questions.. posted pic of boat
« on: November 08, 2010, 03:08:02 PM »
Hey guys, i have a kachina labala 22.5ft jet and tryin to get the most out of my topend,  i have a grade on the intake and was told to take it off and dont put any kind of grade in it and just leave it open.  The grade has 2 El channels on either and and strait stock in the center of the grade, should i purchase a after market grade that directs water at the top of the impeller?  Im running a AA impellar  and pump was just redone.  Can give more detail if asked, any help would be grate.

Thanks.http://

Pages: [1]

Null

SMFPacks CMS 1.0.3 © 2026