.

So not thinking like an idiot I didn't drop the pan to check what it will hold when the motor was out and I don't trust a dipstick that doesn't fit right so here's my dilemma, I only pulled 4 quarts out of the pan, no way that's enough. Even an auto pan takes 5 1/2-6. So I put 5 1/2 in it for the time being. Well I filled it up with vr1-50 and at idle about 1000rpm I'm around 45psi and ill hit 65psi  by 2000 and it will hold all the way to 5000, and this is with the motor at temp of 160-170. What do you olds experts say?

Had to beat you to the water

What a pain in the ass that was. Ill never do it by myself again

Made a nick nack run to ace and found 3ft strips of heat shrink, we shall see if it helps with the cables cracking

Oh it didn't post the picture last time, but got it fired. Just gotta clean up the wiring, put on the transome cover, diverter and hook up the cables

Count the turns from fully closed to open and then close it half way, go off 1/4 turn increments till you dial it in, I set mine up to run about 100-130 when running around and when I'm idling it gets up to 160-180

I squeezed almost 5 laps around Elsinore on 12 gallons and that was 2500-3k the whole time

Yah finally, almost ruined the whole thing though, the rope on the pump snapped half way through the rotation, luckily I had a safety chain and it caught it. Was a pucker moment for sure

Shazam!

Have some pics of them?

Ah ha it worked