401
Lake Mead / Re: Jet Boat Church @ Mead
« on: May 30, 2014, 09:31:42 AM »
Cool cya guys there 
j/k
Sent from my iPhone using SoCalJetBoats mobile app
j/kSent from my iPhone using SoCalJetBoats mobile app
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
402
Engine Mechanical / Electrical / Re: Engine rail kit install
« on: May 29, 2014, 09:57:35 PM »
I will try and get you the measurement from block to end of pto tomorrow
Sent from my iPhone using SoCalJetBoats mobile app
Sent from my iPhone using SoCalJetBoats mobile app
403
Engine Mechanical / Electrical / Re: Engine rail kit install
« on: May 29, 2014, 09:11:42 PM »
You can always wing it and set your driveline in and measure the distance to you pot and do the math with pro and flywheel but I don't recommend it jmo
Sent from my iPhone using SoCalJetBoats mobile app
Sent from my iPhone using SoCalJetBoats mobile app
404
Engine Mechanical / Electrical / Re: Engine rail kit install
« on: May 29, 2014, 09:09:10 PM »
Here's a pic if you don't understand I added a quarter inch since the plate is that thick. Keep in mind of your planning on using a Hardin marine or Glenn wood deal it varies in bell housing length
Sent from my iPhone using SoCalJetBoats mobile app
Sent from my iPhone using SoCalJetBoats mobile app
405
Engine Mechanical / Electrical / Engine rail kit install
« on: May 29, 2014, 09:05:49 PM »
From the where the front of the pump ends and where you can see the splines. It can vary from the difference in drive lines a 1350 driveline is only 6 inches long where a 1310 is 71/4 long
Sent from my iPhone using SoCalJetBoats mobile app
Sent from my iPhone using SoCalJetBoats mobile app
406
Engine Mechanical / Electrical / Re: Engine rail kit install
« on: May 29, 2014, 09:00:22 PM »
81/2 from front of pump to plate but who knows with your angle and set up
Sent from my iPhone using SoCalJetBoats mobile app
Sent from my iPhone using SoCalJetBoats mobile app
407
Engine Mechanical / Electrical / Re: Engine rail kit install
« on: May 29, 2014, 08:59:40 PM »What is it that I am not understanding? After reading this method I still don't understand how that will help my engine placement vecause I still don't know the distance between the flange of the driveline and the block. It helps with alignment but not forward and aft engine placement.part of your alignment has to do with we're your engine sits and how far forward and back. 8 1/2 inches is typical but every boat is different with width if stringers twist some rails on one side is slightly lower then the other due to the boat etc etc.
Sent from my SCH-I535 using SoCalJetBoats mobile app
Sent from my iPhone using SoCalJetBoats mobile app
408
The No Wake Zone / Re: Arial GoPro
« on: May 29, 2014, 08:52:03 PM »Yeah...until it flew awaytjats twice now 👎
Sent from my SCH-I545 using SoCal Jet Boats mobile app
Sent from my iPhone using SoCalJetBoats mobile app
409
Random Boat Parts For Sale / Re: Steering wheel nozzle and valve covers
« on: May 29, 2014, 07:23:56 PM »
Bump for valve covers and e nozzle
Sent from my iPhone using SoCalJetBoats mobile app
Sent from my iPhone using SoCalJetBoats mobile app
410
Engines / Engine Parts For Sale / Re: Oval port bbc tunnel ram and carbs 1050 dominators and single plain oval port mani
« on: May 29, 2014, 07:14:00 PM »
Bump for dual plain
Sent from my iPhone using SoCalJetBoats mobile app
Sent from my iPhone using SoCalJetBoats mobile app
411
Events / Re: checking water level
« on: May 28, 2014, 11:01:36 PM »
Won't be able to boat a cfw there holding the njba races this weekend
Sent from my iPhone using SoCalJetBoats mobile app
Sent from my iPhone using SoCalJetBoats mobile app
412
The No Wake Zone / Re: What did you do to your boat today?
« on: May 28, 2014, 04:37:45 PM »Is that your alternator sitting on your k itching counter???ueah when I got home a buddy wanted to see a pick so slapped it in the granite countertop
Sent from my iPhone using SoCalJetBoats mobile app
413
Events / Re: Big River Fathers Day Weekend 2014
« on: May 28, 2014, 04:35:15 PM »I'm not sure about us but I know onegps now your taking the fun out of things mr camp director. I look at it this way if I can stumble back to the bates motel I'm good to go
SCJB sparkly jet boat owner that will
be there with bells on. Alls I can say is
look out Dumas Walkers, and somebody make sure he has a gps at
closing time ! It's dark out there.
ha ha ha...
Sent from my iPhone using SoCalJetBoats mobile app
Sent from my iPhone using SoCalJetBoats mobile app
414
The No Wake Zone / Re: What did you do to your boat today?
« on: May 27, 2014, 09:53:11 PM »
Got some more bling done for the boat
Sent from my iPhone using SoCalJetBoats mobile app
Sent from my iPhone using SoCalJetBoats mobile app
415
Engine Mechanical / Electrical / Re: Engine rail kit install
« on: May 27, 2014, 09:42:02 PM »I was wondering if I can do this if I dont have a flywheel and crankshaft installed. I have done a lot of searching on this subject but haven't seen if it can be done without those parts. Is there a measurement from the jet input shaft to the rear of the block that will get me close. If I had those parts I think I could have been done by now...anyone have a junk crankshaft?yeah depending on what drive slime your boat is running and pto
Sent from my SCH-I535 using SoCalJetBoats mobile app
Sent from my iPhone using SoCalJetBoats mobile app
416
Jet Pumps / Re: Shoe but NO ride plate
« on: May 27, 2014, 09:32:37 PM »The shoe doesn't only load the pump but also adds lift. When you add lift the boat needs something to rock back on. That's where the ride plate comes into play. If you are going to cut the intake for the shoe why not do the plate too. It's only going to help. Especially with that big boat and more power.
Sent from my iPhone using SoCalJetBoats mobile app
[/quote
I'm agreeing with jake 👍
Sent from my iPhone using SoCalJetBoats mobile app
417
The No Wake Zone / Re: SoCalJetboats Sightings
« on: May 27, 2014, 03:23:19 PM »whit ford flex is a buddy of mine with the orange and white spectra 20
Sent from my SAMSUNG-SGH-I337 using Tapatalk
Sent from my iPhone using SoCalJetBoats mobile app
418
Project Boats For Sale / Re: Texas tunnel for sale.
« on: May 27, 2014, 01:48:19 PM »i kinda want to keep it all together. But I'll let you know if I decide to part it out.thanks
Sent from my iPhone using SoCal Jet Boats
Sent from my iPhone using SoCalJetBoats mobile app
419
Project Boats For Sale / Re: Texas tunnel for sale.
« on: May 27, 2014, 12:19:48 PM »
If your gonna part out a few things I would be interested in the seats and whole steering set up
Sent from my iPhone using SoCalJetBoats mobile app
Sent from my iPhone using SoCalJetBoats mobile app
420
Jet Pumps / Re: Shoe but NO ride plate
« on: May 26, 2014, 11:47:33 PM »
Just drag her over and I will glass the holes in
Sent from my iPhone using SoCalJetBoats mobile app
Sent from my iPhone using SoCalJetBoats mobile app
421
Jet Pumps / Re: Shoe but NO ride plate
« on: May 26, 2014, 07:47:59 PM »
You can achieve loading the pump with different loader grates and even run it a little deep like I did to keep the pump loaded
Sent from my iPhone using SoCalJetBoats mobile app
Sent from my iPhone using SoCalJetBoats mobile app
422
Jet Pumps / Re: Shoe but NO ride plate
« on: May 26, 2014, 07:46:58 PM »
Jmo is ditch the plates and put a shoe Znd ride plate on. Ask Ralph how his boat liked it after we did his 👍
Sent from my iPhone using SoCalJetBoats mobile app
Sent from my iPhone using SoCalJetBoats mobile app
423
The No Wake Zone / Re: Lake naciemento
« on: May 26, 2014, 02:44:08 PM »
Here's a few pics from heritage ranch my buddy sent me 👎. Looks like we're gonna have to use the main marina launch in a few weeks
Sent from my iPhone using SoCalJetBoats mobile app
Sent from my iPhone using SoCalJetBoats mobile app
424
The No Wake Zone / Re: Lake naciemento
« on: May 25, 2014, 10:25:30 PM »Just got back from being at lake naci for 5 days. While it was low theres still plenty of water there!so you made it to the narrows or Los topples 😜
Sent from my iPhone using SoCalJetBoats mobile app
425
The No Wake Zone / Re: Lake naciemento
« on: May 25, 2014, 09:29:50 AM »
It's sad but naci was origanly built to store water for the farmers instead of a recreational lake but over the years of building it's turned into quite a great place to go boating. Plus side an inch of rain equal a ft a of shoreline. Just gonna suck when the water coves up and have to pull all the tag lines before the dock goes floating away
Sent from my iPhone using SoCalJetBoats mobile app
Sent from my iPhone using SoCalJetBoats mobile app