I run the red blaster 2 and haven't had any problems. I tow the boat as needed and don't run on choppy water to much though. I also bought it before I found out about the marine one..


Sent from the Waterwheel crew

Water wheel resort  north of Blythe have fun everyone. Be safe 😎🏁🏁


Sent from the Waterwheel crew

Couple of friends going up one in a white kurtis craft the other in a eliminator bubble should be a good time


Sent from the Waterwheel crew

That's pretty normal guys.

That's just a cooling ring for when the exhaust crossover is used. It is blind and goes nowhere. Use the little metal block off plates and bolt it down.

Thank you for the help GT I appreciate it.


Sent from the Waterwheel crew

So I finished scraping off the old gaskets getting ready to set on my new intake manifold when I realize there's a square port that is exposed that was covered by the old manifold what am I missing here?

The new manifold is a victor Jr stamped 2904.. The old one was an edelbrock performer 2-0 stamped 2161
Motor is a 454 gen IV..
 I also looked at the markings on the heads and curious to see what anyone knows about them "3964290" any help is appreciated and thank you in advance


Sent from the Waterwheel crew

He's some pics I gathered up


Sent from my iPhone using SoCal Jet Boats

new member.. recently picked up a 78' rogers bubble deck 454bbc jg pump. just put on a holley 750 double pumper and the msd 6al kit have a couple grand burning a hole in my pocket 25 years old and wanna haul ass.. anyone wanna help me spend my money