Wow Finally Got the Ride Plate off Was told a Trick that Worked Well  Heated Bolts with Torch and applied Bees Wax All But the one I had already Stripped came out No Problem
https://www.dropbox.com/s/c6ol0j9a42l5beg/2012-11-08%2017.06.58.jpg



Would I be Correct to Assume that if it has Corrosion around were the bolts and the seal would be that means that air had to be getting in ?

I Just found this post after using GT Terminology " ride plate " as they say half the battle is knowing the Language. I do remember this problem started after running aground and we took on allot of water was all the way up to the bottom carb. to keep from sinking I dropped the deck bilge pump down into the ski compartment I had boat at max capacity when this happened my right arm does not work so my wife and daughter had to jump out and help push the boat off the sand bar that we never should have hit but I was drafting to deep. I have since replaced the bilge in the engine compartment. but I bet that did not fix the problem just removed the symptom of filling up with water. i bet that very same leak is causing air to mixed with water IE Cavitation. I do remember the boat shooting out a very noticeable rooster tale in the past now it just looks like allot of white wash kind of like a hot tub. I still plan on checking STATOR and switchbox's as well maybe even first as it is less labor. and I will have to get help.

http://www.justanswer.com/boat/3ugy9-1994-bayliner-jazz-merc-90-sport-jet.html



Response From Expert


You are getting aerated water. Remove the ride plate and inspect all the areas of the exhaust. Here is a diagram of the exhaust and where there can be problems. The exhaust blows out of the red areas disturbing the water flow and causing cavitation. Was the correct impeller installed same as original


Read more: I have a 1994 Bayliner Jazz with a merc 90 sport jet. Has - JustAnswer http://www.justanswer.com/boat/3ugy9-1994-bayliner-jazz-merc-90-sport-jet.html#ixzz29WTFXbMd

Hello  Thanks in advance for any help

I have a 2001 Sugar Sand Tango with 210 HP Mercruser it was running fine 45 to 50 mph with a 600 lb Load all of the suddent now it will not do over 15 to 20 mph at WOT. I took the Impeller housing off Coated with JB Weld Sanded down Replace extreamly tight Tollerance Impler looks Good I used Marine Grade Silcone around the ride plate to Haul gap trying to make sure I was not getting air bubles. I am at witts end I am a Disabled Vet very little Income. Realy cant even afford a Boat but I stole it for 500.00 running. But I cant give it up because its Just Good Family Time at least it was. Can anyone help I realy dont know what to try next. I have a very High Mecahnical Aptitude and acsess to allot of tools, I am just stummped at

1 What Cuased the Problem

2 How to Fix.

Thanks
GOD Bless
Marvin
321-369-8798