I have a fresh 454 .030 over pump gas, hyd roller cam, edelbrock aluminum heads, single 4150 carb. About 500HP. $6000  I can text pictures.  Mike  949-690-4995  Also have a pump gas 638 inch but might be a bit much for your friend. About 800HP.

Got some pics put on with help of a young person!

580 inch BBC, Dominator pump, gray tweed interior. Runs 90mph at Elsinore. $12K complete or will sell less motor for $3500. Ran 80 with 550HP 468. Can text pics. I will try to get some put on here, just not a good computer guy. Mike  949-690-4995

I might be able to use those.  Mike  text  949-690-4995

Yes, call or text 9496904995

I have had some calls asking for engine specs. so here they are. Bowtie tie tall deck block, 4.530 bore. Scat lightweight crank, 4.500 stroke. Eagle H beam rods. JE pistons at 10.2 CR.Crower 4/7 swap cam, 274-274 at 112'LSA. 748 lift with 1.7 comp rockers. Comp solid roller lifters. Howards timing chain. Milidon 10qt jet boat pan.  Brodix -2 full ported heads, Edelbrock Victor 454R ported and polished intake manifold. .120 wall pushrods, stud girdle. Built engine in february, been to the lake 3 times to test and tune. Engine made 860HP on dyno with 12.5-1 compression, now has 10.2. Text 949-690-4995 Mike

Looks alot like my old 21' 1986 Baker. How much you need for this?

Pictures sent

Is the scoop for 4500 or 4150 carb?

10-1 pump gas, early iron oval port heads, Crower solid roller cam, tunnel ram with 2 660 carbs. Freshened this past summer. New, bigger motor ready to go in. This 468 runs 80MPH at 5400 in my 19' Challenger. I was at the Flat Bottom event Jan 1st at Elsinore. I would need help getting pics posted but can text them. Dependable and well tuned motor. Thanks for looking. Located in Fallbrook, Ca.  $4000.00 OBO   Mike  949-690-4995

So where exactly is the event? I would like to attend and bring a couple friends with fast jet boats.