Looking to sell some BBF Parts
-Weiand Stealth 8012 intake that has just been re polished as well as a little massage of the ports - $200
-Trickflow (I believe 8.550, will double check when I get home) 3/8" .080 chromoly Pushrods - $75
-ProComp 1.73 7/16" stud Roller Rockers with PolyLocks - $65
-460 2 bolt block (not sure of casting as it's at machine shop) is freshly bored .75 over right now to 4.435, ready for final hone. Tried to get it to clean up at .080 over but it will need one sleeve for sure, "maybe" 2, block is zero decked to 10.300. Block will need to be line bored as well. - $100
- Glenwood rear motor mount/bell housing (no feet)- $50
-Everything was on a 521, I am going a new direction and have some left over parts, prices are OBO. Located in La Verne

My weekend was pretty good. Ended up shearing the roll pin that holds the distributor gear on Friday afternoon but my problems were mild compared to what I saw. My buddies and I were tubing behind his Mastercraft Saturday evening and saw a guy drive his 19' Bahner II tunnel hull on the rocks and sink it. My buddies and I were first on scene and the three passengers were ok. We ended up towing/dragging it down the the next beach and where we got the water out of it and on the trailer for the owner. The worst part is the owner was not in the boat, his son in law was driving and the boat had only been in the water 30 min. I was really bummed about my boat till this happened and I realized, hey it could be worse. I will get some pics up and soon as my bro gets them to me.

Been cruisin around the site for a while now and decided its time to post. My boat is a 92 Eliminator Formula with a 532 BBF and American Turbine pump.






Uploaded with ImageShack.us