Null

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Horizonjet

Pages: [1] 2 3
1
Boats For Sale / 72 Horizon Jet Boat $2500
« on: December 01, 2015, 04:41:28 am »
Wanting to sell my Horizon Jet Boat to move up into something better. 24 hours on BBC 468, roller lifters, holley 750, Stewart Warrner guages to keep the old school look. Place Diverter,  etc. Tires on trailer 3 years old interior decent. Some fading on original gel but can be shined up.

2
Boat Racing / Drag Boat freind looking for help
« on: October 16, 2015, 06:34:00 pm »
I have a freind from high school in Oklahoma thats coming out to Phoenix to drag boat race. He is currently 1st in his class, his name is Jeff LaBlanc and his boat is Blown Crazy. He is in need of sponsership or help since this is 1000 miles here and 1000 miles back. Any little bit would help. If you could sponsor he can get your name or business name in the annoucer book. If interested pm me and i can get you his number. Thank you

3
Engine Mechanical / Electrical / Fuel Pump/Regulator ???
« on: October 12, 2014, 12:19:46 am »
I bought a new electric fuel pump in july and just now got around to installing it. It was supposed to be carb. friendly and only be rated to about 9 psi.  I installed it today and it pegged my fuel pressure guage.  Question is if I get a fuel pressure regulator do I need the one with the return line or will the regulator without a return line be sufficient?

4
Suggestions / Support / 98 Silverado Z71 4x4 growl noise
« on: September 15, 2014, 10:34:12 pm »
I am running out of ideas, I have a 98 Z71 4x4 and driving in 2 wheel drive it makes a growl noise from the front end after about 40mph, put in 4 high and it goes away and stays away when going back to 2 wheel dr. when in 2 wheel it does not drive like its in 4 wheel so I know it is not stiking in 4 wheel dr. Is this a common problem with these? it has 115k on it. Other then that it runs good, shifts good, etc.  Any ideas will help.

5
Engines / Engine Parts For Sale / Chevy Cavalier A/C inop.
« on: July 08, 2014, 08:11:57 pm »
My sons a/c quit working on his car. Turn it on and compressor clutch engages, coming fan comes on then after a min. Comp. Shuts off, then comes back on for a min. them shuts off again. I thought it might be low on freon but the gauge on the can says its really high pressure in the red so it ain't low on freon. I'm stumped now? Any ideas? Compressor turns freely by hand. Compressor ain't noisy when running.

6
Engine Mechanical / Electrical / Carb PSI
« on: June 30, 2014, 10:12:54 pm »
I have a problem with stalling after running for 30 to 60 seconds at about half throttle. Changed a few things and woke up in the middle of the night thinking its running out of fuel.  Idles all day long and after it dies give it a few seconds and it would start back up, idle, and then go again for about 30+ seconds then die. idle all the way back to the dock.  I changed the fuel filter and moved fuel pressure guage where I can turn around and see it.  Ran much better almost without dieing but any more than half throttle and fuel pressure goes to 0 and then starts to sputter then I let up on throttle and fuel pressure climbes to about 2 to 3 and will run all the time, floor it again and pressure goes to 0 and does it all over again. Im thinking fuel pump. at idle it pumps 6psi all day but cant keep up when cruising, is it normal for the fuel pressure to go all the way to 0? I don't think it should and thinking of replacing electric pump with a carter p4070. Anyone use that one before? Or should I do Holley Red? right now im running what it came with and that's a facet noisy electric and dont really want to do that one again.or if there are any other suggestions/brands that may be better

7
Cars / Automobiles For Sale / 98 Firebird overheats
« on: June 23, 2014, 10:43:17 pm »
HI! I just acquired a 98 firebird 3800 v-6 an you cant even go 2 miles without overheating and then a hiss noise from middle of intake.  It has a new water pump but you can see that if it were leaking, and t-stat. it has no water in the oil and it does not blow water out of the exhaust. Looking for opinions and maybe someone has had some experience with this. I don't think it head gaskets. I got it for less than 1000.00 and its red with t tops.  and guesses on what it might be??  This is a car and not a boat.

8
Engine Mechanical / Electrical / Broken Holley
« on: May 18, 2014, 02:36:18 pm »
I rebuilt my holley carb and was installing a plate that holds the throttle cable and when I tightened down carb I broke off the tab on the base plate :( I don't know if this can be welded back or see if I can find a base for a 3310.... I wanted to go to the lake but now I can't....what to do, what to do......

9
Engine Mechanical / Electrical / What is this starter?????
« on: March 29, 2014, 12:48:13 pm »
I'm replacing the starter in my boat and it has a BBC. Nobody around here knows what this starter is. I had to pull the motor to replace but nobody how to look up this. Does anyone know what this might be from? It bolts to housing around flex plate from engine side.

10
Jet Pumps / trouble installing place diverter
« on: March 15, 2014, 07:33:03 pm »
I am installing a place diverse on a JC Berk and I wrestled with it all day and still not complete. The pins that hold it to the bowl, the top one is too long but that ain't all. The holes for the place diverter were stripped, I tapped them and conquered that. Come to find out it was a hydraulic place D and the cable that was sent won't mount I'm the hole on the arm for the tilt. I know others have converted from hydraulic to manual. The cable is like a throttle cable  and don't have the big nuts like the reverse bucket cable. What do I do now?

11
WTB / WTB Place Diverter & floor handle
« on: January 11, 2014, 09:14:18 pm »
I WTB a place diverter and floor handle for a Berkley JC. Just looking to get one cheaper than new and if anyone has one just laying around....  ;D

12
Engine Mechanical / Electrical / Intake manifold questions???
« on: January 11, 2014, 09:12:10 pm »
I am wanting to replace factory Chevy Z-28 intake for BBC this winter and I can get a Edelbrock Victor Jr. 454-o from a friend but what I read about it it recommends 850cfm carb with I only have a 3150 holley which I believe is a 750. Will that be ok? I didn't want to buy a bigger carb too to do this or should I see about a different manifold and which is better single plane or dual?

13
SoCal Lakes / Lake Pleasent AZ
« on: August 30, 2013, 09:53:56 am »
So far its a slow day.....

14
Engine Mechanical / Electrical / Dual or single plane intake???
« on: July 14, 2013, 10:20:11 pm »
I have a mildly built 454 BBC bored out 30 over and good cam and O/T Headers.  I am going to replace factory alum intake to a nice polished air gap one.  Should I go single plane or dual plane and why?  I know one is good for higher RPMS than the other but I am  only turning about 5000 rpms

15
Engine Mechanical / Electrical / BBC Intake manifolds
« on: July 13, 2013, 10:03:08 pm »
I have a mildly built 454 BBC bored out 30 over and good cam and O/T Headers.  I am going to replace factory alum intake to a nice polished air gap one.  Should I go single plane or dual plane and why?  I know one is good for higher RPMS than the other but I am  only turning about 5000 rpms

16
The No Wake Zone / Toronado
« on: May 22, 2013, 09:00:02 am »
I'm from Moore Oklahoma, graduated from Moore High School and lived a mile north from where toronado hut. I know zilla68 lives there but can't get in contact with him. I hope him, his family, and jet boat are ok.

Sent from my DROID RAZR using SoCalJetBoats mobile app


17
Suggestions / Support / Getting IROC from PA to AZ
« on: May 01, 2013, 10:03:03 pm »
My wifes cousin likes us and knows I loved her dads 87 IROC z28 and whe died a month ago and told me today I can have the car for free....  ;D
Problem is how to get it from PA to AZ and shipping by truck will be over 1000.00 or should I fly out and drive my ass off bringing it home.....200.00 in airlines ticket and then fuel and food for way home.  Or is there a better way I am not thinking of??????   Comments, questions????

18
Suggestions / Support / Pool lighting
« on: March 28, 2013, 08:54:31 pm »
I noticed I have rusty water in my pool light. Is this a shock hazard? Do you just take light out and unscrew old bulb and screw in new one? I noticed LED bulbs don't, they are rewired and does anyone know how to re wire if i go this route. I know wiring just wondering if there is anything special since this is underwater.

19
Engine Mechanical / Electrical / My carb
« on: March 01, 2013, 02:29:07 pm »
Is it hard to rebuild a Holley 3310? & where is a good place to get a rebuild kit?  It can't be any harder than a q-jet.

20
Interior / Home Depot carpet
« on: February 18, 2013, 09:18:57 pm »
Finally got around to installing the HD carpet and used there glue with excellant results!

21
Engine Mechanical / Electrical / Carb Problems
« on: February 17, 2013, 09:11:33 pm »
I have not had boat out since july, took to lake in Nov. and it would not start.  Rebuilt carb in dec. fuel in bowls had dried and left a yellow film on everything, sprayed out all passages and it fied up and ran in driveway for 1/2 hour, went to start today and same thing, no start.....no squirting in carb at top.....What do yall recomend for winterization? I use the fuel stabilizer stuff from wal mart in the marine isle thats blue (cant think of name right now) running a holley (3310 I think, cant remember now either)  :beer:  I know its not spark or anything, its just from sitting..

22
Interior / Installing carpet
« on: January 27, 2013, 09:22:49 pm »
Going to be installing new carpet in week or so as soon as the humidity goes back down. What is a good carpet glue, the Home Depot indoor/outdoor carpet glue or should I spriong for the caarpet glue at West Marine?  Any thoughts or ideas?......

23
Events / Merry Christmas and Happy New Year! ! !
« on: December 22, 2012, 10:55:14 am »
Merry Christmas and Happy New Year to all SCJB

Now it can warm up again........im ready......  :D

24
Engine Mechanical / Electrical / Gas gone bad
« on: October 08, 2012, 06:56:03 pm »
I took my boat to lake this weekend and never had trouble starting so I did not run at home before leaving.  Got to lake and it did not start or would sputter and die and not resart.  Gas smells like varnish and it has been in there since fathres day weekend.  Do I need to drain and fill with freash gas, or is there an additive that I can pour in to get it to burn and do I need to rebuild holley carb while im at it?

25
Engine Mechanical / Electrical / HEI with curve kit
« on: October 01, 2012, 09:44:39 pm »
I am running a HEI with no vacume advance on a BBC. Do I still want a advance curve kit or is it not needed now. Just wondering before I spend the big bucks for one...LOL!

Pages: [1] 2 3

Null

SMFPacks CMS 1.0.3 © 2022