SoCal Jet Boats
Classifieds => Project Boats For Sale => Topic started by: gregb on October 04, 2010, 04:33:48 PM
-
1982 Marlin Barracuda model. NO ENGINE or battery. I'm keeping those. Good shape, has the usual scratches and chips but the gel is still shiny. 12JC pump. Diverter. Needs an impeller, a friend managed to injest a few rocks and I'm not sure if it can be saved. (its a B, was detailed by MPD). Has an Ulitimate Wear Ring. One of the stringers was pulling in where the engine mount is, I used a piece of 3/16 stainless plate to reinforce it. Been that way now for 20 years. They are full length stringers. I'm the second owner, had it since 1990. All the gauges work. All the cables move smoothly. Interior decent. 30 gallon center mounted gas tank. (which I was never too fond of, since it takes away some of the floor space). Has a old sport loader or whatever they called them before they became fancy. It's thru bolted. 2 bilge pumps. Trailer decent, not real pretty but not ugly either. Well, maybe a little. All lights work and I redid the wires recently. The wiring in the boat is even new and I used the proper colors. (It used to run low 60's with a mild 350, did 70 with 4 people on board with the 383 that is currently there.) All paperwork is in order and up to date. Trailer has the PTI tag. It will need an engine and the stuff to mount it, bellhousing and the driveshaft. And the impeller. It has a cover that will go with. Like a lot of you, I like boats, but I don't have space for 3 and I just picked up a Rogers hull, so this one will have to go. $1400. I'll also sell it without the jet and diverter for $1000. I haven't yanked the engine yet, so it is possible to arrange a test drive with some notice for anyone with a serious interest. Thanks for looking, boat is in Diamond Bar. Again, will be without engine.
Greg
-
$500, no engine, no jet or diverter. 800 with a jet that will need a bearing as well as the impeller. If you're within 1/2 hour of me I'll even drop it off.
-
800. The pump needs a bearing, the two seals and the packing. Here is a pick of the impeller, looks like it can be fixed. The pump shaft is out and the bearing is off. I'd like to not have to part it out, just need the room.
-
pm sent
-
n/m
-
PM Sent
-
PM's replied. Also, I replaced the front bearing and the two seals.