Looks like a 64 tucked away in the corner??


Sent from my iPhone using SoCalJetBoats

Yup, that will get started sometime next year.

Nice! I like the dzus fasteners, gives it that "race" look.


Sent from my iPhone using SoCalJetBoats

What did you use to cut the hole for the carb in you scoop tray I'm going to make one this weekend no one sells a tray for my scoop

Sent from my SGH-T999 using SoCalJetBoats mobile app

They sell blank trays everywhere berkbryan,, also you can order them frm jegs $80 or by my work they cut bend em to ur specs $75 cutting hole easy!! Jake u are on fire to make tom papps! That is ur dead line huh.. And then u can bring me my dam shirt lol

Thanks bud! Yeah Papp is the deadline. I got ya bud. I figured I would get it to ya then. Sorry for the long wait. It's on me now.


Sent from my iPhone using SoCalJetBoats mobile app

Good stuff 👍

Sent from my SCH-I545 using SoCalJetBoats mobile app

Got the electric bracket done. Made it with 1/4 inch angle aluminum. Broke one of the terminals so ill replace that tomorrow.

Great job on the boat and keeping us updated with the details and pics.  Thanks.
After the wiring, what do you have left to do?

Thanks man. After wiring I have pluming and steering and cables. That's should wrap it up.


Sent from my iPhone using SoCalJetBoats mobile app

Lookin good brotha! Are the motor mounts Madskillz specials?

Nice work it's looking good

Sent from my SCH-I545 using SoCalJetBoats mobile app

pushed that motor a little forward huh 

Thats about where they had rigged it before. Its actually 4 inches closer to the transom that before.

Picked up about half of the fittings from one of my sponsors for the 177 boat this afternoon. Man that really helps lol Just one of the Hose ends was 15.00$ Da Hell!!!?


I am pluming all the fuel with -8 AN's and stainless steel line.
The water will be -8AN's in to an gate valve and a pressure relief valve. -10 AN out.

Anybody who had done this knows that it sucks. But..... I picked up a tool that makes putting the fittings on the hose super easy!!!!!

Its called the KOUL TOOL. You put the part of the AN that goes over the hose in the KoUl tool
BUY THIS TOOL! It makes assembling AN's easy!!!!!





Close it and put it in a vise and push the line in. Boom Done!
















I need to pick up another 1/4NPT to -8 90* for the in side of the fuel pump. It wont fit wit a straight AN. It hits the Oil filter. Also need to pick up a inline fuel filter at some point.

Got more done today on the fittings and lines.