Okay so she ran good today I just need to close the water inlet on my pump down a little bit more because my operating temp was like only 160 ish at idle but I would drop way down to like 130 128 or so when I got on it had a little leak just had to tighten up one of my an fittings that was it. and tighten up the nuts on the pump where you're packing seal are so it was just a drip cause when I first put it in the water  it was a stream. The wind picked up so I only idled around n make to quick passes only to about 4000 rpm because water was sooo rough . she didn't seem very fast though idk need some glass or the river to try on

Sent from my SPH-L900 using SoCal Jet Boats mobile app

It couldn't be more dead nuts if you had an Oompa Loompa adjusting it while under way ..

GT