What size shaft does a Panther Jet have

« **on:** May 18, 2013, 04:16:03 PM »

I have a 1979 Galaxy with a panther jet in it . I have a slip yoke but its not quite long enough I want to know what size it is to try finding a new slip yoke but I don't know what size it is I am getting a vibration from the u joints and I don't think my yoke is long enough it barley fits on the shaft I have now but I can not slip it back due to the protection cage on the panther jet . Can anyone help ??

« **Reply #1 on:** May 18, 2013, 08:26:33 PM »

IS it the 1310 Splicer that Fits it

and also can u buy Longer 1310 Slip yoke ??

« **Reply #2 on:** May 18, 2013, 10:57:10 PM »

First off, I dont know anything about panther.
However Berk and Jacuzzi use a 10 spline 1 and 1/8th inch 'major' diameter. If panther is the same, CJ7 Dana 20 front driveline yoke fits and there is a few new forged units available, but length may be a problem on yours.

Hope this helps

Daniel

« **Reply #3 on:** May 19, 2013, 09:33:38 AM »

I know it is smaller that a Berkley I am just not positive of what the shaft size is . if i can not figure this out i could use the same slip yoke i have now but could I put a spacer plate on the pto

? has anyone ever done this ??

Got Jugs

What size shaft does a Panther Jet have

Got Jugs

Re: What size shaft does a Panther Jet have

mash on it

Re: What size shaft does a Panther Jet have

Got Jugs

Re: What size shaft does a Panther Jet have