SoCal Jet Boats
Discussion => The No Wake Zone => Topic started by: SEX_FEET_DEEP on June 09, 2009, 04:25:26 AM
-
IN THE PROCESS OF SHOPPING AROUND RIGHT NOW FOR MY FIRST JET BOAT. I'VE OWNED JET SKIS FOR ABOUT 6 YEARS AND READY TO GET SOMETHING MORE FAMILY READY. JUST CURIOUS WHAT ARE SOME IMPORTANT THINGS TO LOOK AT WHEN BUYING. I GOT MY EYE ON AN 84 ELIMINATOR WITH A 496 AND A BERKELY. IT HAS BEEN USED IN SALT WATER. IS THERE ANYTHING OTHER THAN OBVIOUS SALT SCALE(CORROSION) TO LOOK OUT FOR IN A SALT WATER BOAT. ALSO JUST GENERAL CONCERNS TO PAY ATTENTION TO ON ANY JET BOAT.
THANKS IN ADVANCE
-
Once you take a salt water jet and run fresh water through it awhile, should clean up the scaleing I would think. Pitting would be another issue.
Sounds like you found a boat, if you're comfortable with the price. Fresh water boats have their own problems, such as sand in the block, etc. The main thing is the boat. Engines and jet drives can be easlily replaced and rebuilt. In this economy, you can buy replacements at bargain basement prices, so I would worry about the hull and whether you like it or not. And whether it's a deep v or very shallow v for your intended use. (Or tunnel, gullwing, pickle fork or whatever).
Have (or HAD) 1 of about everything, the deep V was a great cruiser! My shallow V (and VERY shallow) is a kidney buster, but I'm getting better driving it to avoid a lot of that bouncing! The Hallet I got from B-Rad, lord I dunno, much flatter than the Moo and I'm thinking a Blown engine in the Mofo! (we got sumthin planned Brad, you're not allowed to know.....)
Terry's gonna show me what bouncing is in a couple weeks in his flattie I'm sure!
Ray
Someone, Glenn (GT) Most likely, will chime in with much more knowledgeable information I'm sure.
-
IN THE PROCESS OF SHOPPING AROUND RIGHT NOW FOR MY FIRST JET BOAT. I'VE OWNED JET SKIS FOR ABOUT 6 YEARS AND READY TO GET SOMETHING MORE FAMILY READY. JUST CURIOUS WHAT ARE SOME IMPORTANT THINGS TO LOOK AT WHEN BUYING. I GOT MY EYE ON AN 84 ELIMINATOR WITH A 496 AND A BERKELY. IT HAS BEEN USED IN SALT WATER. IS THERE ANYTHING OTHER THAN OBVIOUS SALT SCALE(CORROSION) TO LOOK OUT FOR IN A SALT WATER BOAT. ALSO JUST GENERAL CONCERNS TO PAY ATTENTION TO ON ANY JET BOAT.
THANKS IN ADVANCE
Other than the obvious (corrosion etc) if its been flushed and cleaned it should be fine Call if we can help Tom
-
SIX_FEET_DEEP, if thats even your real name LOL..
Other than what's already been said, plan on breaking an ass load of bolts, get a good set of easy outs and some Cobalt drill bits and you'll be fine...
Over the last several years, I have seen more than my fair share of salty dogs...Really not a big deal on a jet since there are very few bolts (as compared to a vee driver or an I/O...).
Some areas of concern on a salt boat....head gaskets (if marine spec not used), intake manifold (only really an issue on aluminum), distributor (not only will they sieze in the manifold, but the advance weights get jacked), and lastly the impeller (again, only on the aluminum deal), and aluminum exhaust manifolds don't live too long in salt.
If this thing floats your, well, you know, I say go for it, unless it's really obvious, it can't be that bad....
GT