SoCal Jet Boats
Discussion => The No Wake Zone => Topic started by: jyeager on June 24, 2014, 09:00:14 PM
-
Alright boys, need some advice of where to start with the hardware with the dimarco. I've only done tunnels so.... I was thinking nozzle at 6*up and rideplate at 4* up. Shoe 1/8th above keel and the loader ramps are 1/2 inch above keel.
What do you guys think?
Sent from my iPhone using SoCalJetBoats mobile app
-
Seems like alot od nozzle angle. I would start at 4* and run the shoe even
Sent from my SAMSUNG-SGH-I747 using SoCal Jet Boats mobile app
-
rideplate at 3 degrees up
nozzle 3-4 degrees up from keel. I assume your intake is 4 degrees down? ....so 6-7degrees up from pump angle.
not sure about shoe and loader, but i'd start with the 2 above and work on the 2nd 2 after that.
-
rideplate at 3 degrees up
nozzle 3-4 degrees up from keel. I assume your intake is 4 degrees down? ....so 6-7degrees up from pump angle.
not sure about shoe and loader, but i'd start with the 2 above and work on the 2nd 2 after that.
3 up? Sounds like not a lot of up for the ride plate. I'll try that and work from there. Yeah intake is in at 4.1 and 3* back cut shoe. Also the nozzle is angle is in relation from keel and the intake
Sent from my iPhone using SoCalJetBoats mobile app
-
A