SoCal Jet Boats
Discussion => The No Wake Zone => Topic started by: TJS Nordic on March 05, 2008, 05:13:53 AM
-
Here are some "dyno" headers where the person requested I welded in the sensor bungs to each tube (old school, should be 02 bungs for wideband). This is for a Big Block 70 Camaro with a large ATI blower (had a vortech before). I also did the inlet tube with the blow-off on it. I had to make the tube between the large tube and the valve and weld the inside of the triangle part to the tube :mad:.
I want to dyno my BBC for my boat but do you think using dyno headers with the same tube diameter I am running on my boat will be close enough.
T.J.
(https://www.socaljetboats.com/proxy.php?request=http%3A%2F%2Fwww.tjsperformance.com%2Fimages%2Fdynoheaders.jpg&hash=34ee6f8087b2973c7924d018936b1c124eab148d)
(https://www.socaljetboats.com/proxy.php?request=http%3A%2F%2Fwww.tjsperformance.com%2Fimages%2Fvortechblowoff03.jpg&hash=8a1ecc209812576b99c04834a82512d406cb3a80)
-
if ya have headers on the boat...yep! Even if ya have logs you'll have a baseline. Lean it a touch for logs after dyno with headers and run it. Dyno with the air filter!! Bring several,,, it's an eye opener!! ;D