SoCal Jet Boats
Discussion => The No Wake Zone => Topic started by: 76 Bonneville on October 11, 2008, 07:02:27 PM
-
Do any of you have pics of where and how you mounted your kill switches?
-
My OP ,just about any where its convenient .. Tom
(just to the right of the drivers seat)
(https://www.socaljetboats.com/proxy.php?request=http%3A%2F%2Fi147.photobucket.com%2Falbums%2Fr319%2Fjetboatperformance%2F69%2520Schiada%2FDSC00460.jpg&hash=d451e2ca2f50981f5729baf017a298fdc4f51b3a)
on the stringer rail
(https://www.socaljetboats.com/proxy.php?request=http%3A%2F%2Fi147.photobucket.com%2Falbums%2Fr319%2Fjetboatperformance%2Fufo%2FDSC00106.jpg&hash=a4e93061afb379cff3174922d020abdd8bd2c5ef)
-
Do any of you have pics of where and how you mounted your kill switches?
There's a couple of ways you can do this the easiest is the positive wire running to the coil,you can buy the switch at your loco auto parts store,the switch goes in between the the coil wire wright behind the dash,so for a clean set up your going to have to drill a hole in the dash mount it some easy to get to fairly easy. good luck
-
Right now its set up with a mag. and a kill button on the dash. I guess i could tap into the ground wire and the wire that kills the mag. and bring those down in front of the seat. All that would do is give me two points to kill it. I just want to have it set up, so if we decide to race everything is in place.
-
That might work, much easier if you go off the ignition wire save you some time the wires are already their just my o2
-
That might work, much easier if you go off the ignition wire save you some time the wires are already their just my o2
-
Old school kill switches for mags were real simple. Replace your button with a water proof toggle. and add an Eye Bolt about an inch to the "engine off" side. Put a loop in your lanyard and thread it through the eye bolt and over the toggle. Tie the lanyard to your jacket and go racin. Toggle away from eye bolt, motor on. Toggle toward eye bolt, motor off. Driver leaves the vicinity toggle gets pulled toward eye bolt, motor off. be sure you leave enough slack in the lanyard so it doesn't go motor off if you move a bit in the seat.
-
Kill switch hmm pussy's
I say just flat foot it till it blows......Motors off
Any questions :D
-
Sorry, should have posted yesterday. Mounted the kill switch to the front of the seat pedistal, then ran the wires in a piece of 3/8 fuel line under the seat and up to the wiring harness. Ron
-
Atta boy Ron ! Best place IMO .
-beerjet-