SoCal Jet Boats
Discussion => The No Wake Zone => Topic started by: Bebo on July 08, 2012, 07:26:48 PM
-
Hey guys whats going on. I have a problem with all the wiring under my dash. Not the ones from the ignition but from my stereo speakers and amp thats under there. What would be the best way to tuck them up..under the dash is only fiberglass so cant glue anything and i want it to be easy and simple if possible. Thanks guys all feedback will help
Bebo
-
well if you have time and somethin really trick! run them all in clear tubing.then use gorilla glue to hold the tubing up.
-
cushion clamps... best way to hold anything in a boat. wires, fuel line, water lines, etc.
(https://www.socaljetboats.com/proxy.php?request=http%3A%2F%2Fa2.sphotos.ak.fbcdn.net%2Fhphotos-ak-ash4%2F459014_10150903964524833_996035584_o.jpg&hash=271d2473df641a2a673f715083ae2696987cb9aa)
-
I used A B epoxy. You could also glass in some strap metal to run it through if you don't have wood to screw into.
-
yeah sorry about the typo..i meant i cant screw anything becuase its not the dash its the whole front of the boat the underside so if i did screw something itd go right through my deck. I dont think that much tubing either would be clean. I just want couple points where the wiring is held up and not sagging.. I was thinking velcro straps. glue one end tot eh deck then velcro the wire up. That way i can take the velcro off if i need to get to the wires for some reason.. Anyone think this isnt a good idea?
-
ahh. just run to homedepot and grab some zip tie mounts then.
(https://www.socaljetboats.com/proxy.php?request=http%3A%2F%2Fstuntcams.com%2Fshop%2Fimages%2Fzipmount.jpg&hash=78151ec308756a0bfbec6edc51bee6e624416b32)
just clean the surface with some acetone to get it clean and those should be able to hold up some wiring. they have a sticky side that you just slap onto anything. the 3m ones stick pretty well.
-
that might not be a bad idea. as long as they stick well itl work..If not im sure some super glue wont hurt holding them up ;)