Ok i got everything wired, got no oil in the engine but wanted to check it out. Just wanted to hear the starter kick thats it!!!!

I got nothing, i have power where it should be so i started to check the wires. Im getting the start signal to the soleniod but its not working, now if i jump from the batt side to the start wire. It kicks...

So im guessing bad solenoid??

I have a new one in my shopping basket from jeggs but before i buy it i would like a second opinion

Anyone

If it kicks I would have to say it's not bad.  I would be checking for proper wiring.  Do you have a good ground to the block also?

X2 ground. Is your solenoid remote or part of the starter? Mine is remote or separate. I think it grounds through the case and whatever mtng bracket. I had to rethink my mounting bracket scheme once I ran up against this. But after getting ground it worked great.

Ok i got everything wired, got no oil in the engine but wanted to check it out. Just wanted to hear the starter kick thats it!!!!

I got nothing, i have power where it should be so i started to check the wires. Im getting the start signal to the soleniod but its not working, now if i jump from the batt side to the start wire. It kicks...

So im guessing bad solenoid??

I have a new one in my shopping basket from jeggs but before i buy it i would like a second opinion

Anyone

Not enough poop in the wire after it goes up front and back, I've tried a roll of new wire up and back and no go. Put a relay on it like i told you the other day, takes alot less energy.....jus my .02

A little confused here... which is not hard to do.  
When you turn the key do you get 12 volts at the start terminal??

Not sure about the 12 volts but my test light does light up when i switch the key to on and turns off when key is off

Well if it lights you should be good... Are you runnig a Aux. soloniod like the diagram shows?? If so then it has to be grounded to complete the circiut...

Yes i am, but the other one in the eliminator isnt grounded ... Its grounded to the engine mount. i can go try it

Ok i will go ground the post thats not being used
I also tried to jump it fromt the white wire(batt) to the yellow wire (start) and nothing i still say its bad

forgot you had that thing on there

There's nothing like sweet success in 24 hours or less!