What's up guys? Have a 1990's 19ft Eliminator with a BBC 454.. Took the boat out a couple of weeks ago and it was cutting in and out at high rpm's. Noticed the power wire on the fuel tank seperator valve was loose and when I went to tighten it the threads broke. Anyway put a new one on but as I suspected the problems still there but worse now. Will start up and idle but when giving it any gas it just backfires and dies. Put a Holley 750 on not too long ago and cleaned it just last week. Kind of lost as where to look to now.. Possibly points gap on distributor is out of whack? Any suggestions?? Need to get her going before we head to Parker Thursday!!
Check fuel pressure? What type of ign. Set up? Driveline spin freely? Checked plugs/wires?Old fuel? Just thinking out loud here. Sent from my iPhone using SoCal
I'm kinda leaning towards something electrical ign, coil, dizzy, bad ground, timing. What kind of fuel pump?Is it super smooth up until it cuts out? Or is it rough until it dies? Sent from my iPhone using SoCal
Fuel pressure is good, plugs and wires good, there was a small amount of older fuel when I bought the boat but have ran over 15 gallons in each since, haven't checked driveline
Boat did not want to start this afternoon at all. Just adjusted the points gap and it fired right up and sounded healthy. Gonna run down to the lake and test it out
Boat fired up, but still dieing after giving it gas
If i get some free time tonight at work, ill play with it and post it for everyone to see.
Time to man up and yank it John! Ray