SoCal Jet Boats
Tech Talk => Engine Mechanical / Electrical => Topic started by: Gmoney on February 15, 2016, 09:49:52 PM
-
I have a boat that sat for 2 years and now after new motor installed and ready. Any advice what to add to the tank to clean it up with out removing? Thx
Sent from my iPhone using SoCal Jet Boats
-
I have a boat that sat for 2 years and now after new motor installed and ready. Any advice what to add to the tank to clean it up with out removing? Thx
Sent from my iPhone using SoCal Jet Boats
What's in it? Are they dry? Aluminum? Steel?
Full?
That would dramatically change the approach.
-
I used to dump a bunch of nuts and bolts in the tanks with some water and dawn dishsoap and drag it around town for a few days, then someone suggested filling the tank with ice cubes...easier to pump out than nuts and bolts.
-
It's in a 82 Hallet chrome metal tanks
Sent from my iPhone using SoCal Jet Boats
-
just some stabilizer was added but for the most part it's empty
Sent from my iPhone using SoCal Jet Boats
-
It's in a 82 Hallet chrome metal tanks
Sent from my iPhone using SoCal Jet Boats
Elaborate on the term "metal"
-
just some stabilizer was added but for the most part it's empty
Sent from my iPhone using SoCal Jet Boats
Two gallons of diesel and a nice drive down a shitty road. Pump them out.
Yank the pick up tubes and make sure they're clear. Done.
GT
Sent from my SCH-I545 using SoCal Jet Boats mobile app
-
Not sure what kind of metal but looks like this tank
Sent from my iPhone using SoCal Jet Boats
-
Looks to me like is either stainless or polished aluminum
Sent from my iPhone using SoCal Jet Boats
-
Thx everyone for your help!
Sent from my iPhone using SoCal Jet Boats
-
Double check this one out, with the type of metal you are using. Apple Cider vinegar...
Used it with a rusty tank and it cleaned it right up. Just don't leave it in there for days, wash it out with some old fuel and throw the fuel in the fire when done.
Worked on an old Honda tank that I needed to clean out.
Best of luck!
Shawn