Duplicolor is good.

Just make sure you buy enough cans to lay it down thick.

Primer with the Duplicolor high heat, and make sure everywhere is covering.
Don't sand the primer, just spray the base coat. It usually takes about 3 or 4 coats to lay it down so it all looks even. The first coat you should just haze the paint on, so you don't get runs. While that first coat is taked up you can usually lay a pretty heavy second coat.

And then after the base Duplicolor engine clear realy helps it shine.

Clean the block really good and then clean it again and again if you don't want it peel.

Oh yea that part too lol. Soap and water is good enough if you dry it fast enough so it doesn't rust. Or if you have some Alcohol you can scrup it down with a rag

Acetone!!!

Protect your lungs from Acetone!

Thanks,
I use Acetone on a lot of stuff and it is some nasty sh*t to breath!  I thought that the Duplicolor was some good stuff, I just wanted a second or third opinion.  The motor will have no paint on it as it is being built, but I will still clean it real gooood!

I don't know if it's true or not but I was told that whatever amount of Acetone that you breathe stays in your lungs forever.

I fixed it. Sorry, I can't edit my posts.

VHT is it .

-beerjet-

i use "oneshot" paint its a pinstripe paint and holds up really well. i use a small detail jamb gun and thin it out a little....sticks good!!!! and easy to clean